Temperature‐dependency analysis and correction methods of in situ power‐loss estimation for crystalline silicon modules undergoing potential‐induced degradation stress testing
- 21 January 2015
- journal article
- research article
- Published by Wiley in Progress in Photovoltaics: Research and Applications
- Vol. 23 (11) , 1536-1549
Abstract
We propose a method for in situ characterization of the photovoltaic module power at standard test conditions, using superposition of the dark current–voltage (I–V) curve measured at the elevated stress temperature, during potential‐induced degradation (PID) testing. PID chamber studies were performed on several crystalline silicon module designs to determine the extent to which the temperature dependency of maximum power is affected by the degradation of the modules. The results using the superposition principle show a mismatch between the power degradation measured at stress temperature and the degradation measured at 25 °C, dependent on module design, stress temperature, and level of degradation. We investigate the correction of this mismatch using two maximum‐power temperature translation methods found in the literature. For the first method, which is based on the maximum‐power temperature coefficient, we find that the temperature coefficient changes as the module degrades by PID, thus limiting its applicability. The second method investigated is founded on the two‐diode model, which allows for fundamental analysis of the degradation, but does not lend itself to large‐scale data collection and analysis. Last, we propose and validate experimentally a simpler and more accurate maximum‐power temperature translation method, by taking advantage of the near‐linear relationship between the mismatch and power degradation. This method reduces test duration and cost, avoids stress transients while ramping to and from the stress temperature, eliminates flash testing except at the initial and final data points, and enables significantly faster and more detailed acquisition of statistical data for future application of various statistical reliability models. Copyright © 2015 John Wiley & Sons, Ltd.Keywords
Funding Information
- U.S. Department of Energy
This publication has 31 references indexed in Scilit:
- In-Situ Measurement of Crystalline Silicon Modules Undergoing Potential-Induced Degradation in Damp Heat Stress Testing for Estimation of Low-Light Power Performance2013
- Understanding the current-voltage characteristics of industrial crystalline silicon solar cells by considering inhomogeneous current distributionsOpto-Electronics Review, 2013
- Testing and Analysis for Lifetime Prediction of Crystalline Silicon PV Modules Undergoing Degradation by System Voltage StressIEEE Journal of Photovoltaics, 2013
- Potential Induced Degradation of solar cells and panels2010
- Irradiance-dependence and translation of the I-V characteristics of crystalline silicon solar cells2002
- Spatially resolved analysis and minimization of resistive losses in high-efficiency Si solar cellsProgress in Photovoltaics: Research and Applications, 1996
- Recombination rate saturation mechanisms at oxidized surfaces of high-efficiency silicon solar cellsJournal of Applied Physics, 1995
- Departures from the principle of superposition in silicon solar cellsJournal of Applied Physics, 1994
- Application of the superposition principle to solar-cell analysisIEEE Transactions on Electron Devices, 1979
- Series resistance effects on solar cell measurementsAdvanced Energy Conversion, 1963