Fibrin-Based Tissue Engineering: Comparison of Different Methods of Autologous Fibrinogen Isolation
- 1 March 2013
- journal article
- research article
- Published by SAGE Publications in Tissue Engineering Part C: Methods
- Vol. 19 (3) , 216-226
Abstract
Objective: This study is focussed on the optimal method of autologous fibrinogen isolation with regard to the yield and the use as a scaffold material. This is particularly relevant for pediatric patients with strictly limited volumes of blood. Materials and Methods: The following isolation methods were evaluated: cryoprecipitation, ethanol (EtOH) precipitation, ammonium sulfate [(NH4)2SO4)] precipitation, ammonium sulfate precipitation combined with cryoprecipitation, and polyethylene glycol precipitation combined with cryoprecipitation. Fibrinogen yields were quantified spectrophotometrically and by electrophoretic analyses. To test the influence of the different isolation methods on the microstructure of the fibrin gels, scanning electron microscopy (SEM) was used and the mechanical strength of the cell-free and cell-seeded fibrin gels was tested by burst strength measurements. Cytotoxicity assays were performed to analyze the effect of various fibrinogen isolation methods on proliferation, apoptosis, and necrosis. Tissue development and cell migration were analyzed in all samples using immunohistochemical techniques. The synthesis of collagen as an extracellular matrix component by human umbilical cord artery smooth muscle cells in fibrin gels was measured using hydroxyproline assay. Results: Compared to cryoprecipitation, all other considered methods were superior in quantitative analyses, with maximum fibrinogen yields of ∼80% of total plasma fibrinogen concentration using ethanol precipitation. SEM imaging demonstrated minor differences in the gel microstructure. Ethanol-precipitated fibrin gels exhibited the best mechanical properties. None of the isolation methods had a cytotoxic effect on the cells. Collagen production was similar in all gels except those from ammonium sulfate precipitation. Histological analysis showed good cell compatibility for ethanol-precipitated gels. Conclusion: The results of the present study demonstrated that ethanol precipitation is a simple and effective method for isolation of fibrinogen and a suitable alternative to cryoprecipitation. This technique allows minimization of the necessary blood volume for fibrinogen isolation, particularly important for pediatric applications, and also has no negative influence on microstructure, mechanical properties, cell proliferation, or tissue development.Keywords
This publication has 28 references indexed in Scilit:
- The in vitro development of autologous fibrin-based tissue-engineered heart valves through optimised dynamic conditioningBiomaterials, 2007
- Engineering of fibrin-based functional and implantable small-diameter blood vesselsAmerican Journal of Physiology-Heart and Circulatory Physiology, 2005
- Xenotransplantation: Infectious Risk RevisitedAmerican Journal of Transplantation, 2004
- Use of a Fibrin Preparation in the Engineering of a Vascular Graft ModelEuropean Journal of Vascular and Endovascular Surgery, 2004
- Fibrin gel – advantages of a new scaffold in cardiovascular tissue engineeringEuropean Journal of Cardio-Thoracic Surgery, 2001
- Potential risks of viral infections in xenotransplantationActa Tropica, 2000
- Fibrin gel as a three dimensional matrix in cardiovascular tissue engineeringEuropean Journal of Cardio-Thoracic Surgery, 2000
- Tissue Engineered Neocartilage Using Plasma Derived Polymer Substrates and ChondrocytesPlastic and Reconstructive Surgery, 1998
- Evaluation of matrix scaffolds for tissue engineering of articular cartilage graftsJournal of Biomedical Materials Research, 1997
- Biodegradable Polymer Scaffolds for Tissue EngineeringNature Biotechnology, 1994