Dimension Influence on the Interface Fatigue Characteristics of Three-Dimensional TSV Array: A Fully Coupled Thermal-Electrical-Structural Analysis
- 3 September 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Device and Materials Reliability
- Vol. 24 (4) , 571-583
Abstract
As the interconnected structure of 3D chip, through.silicon via undertakes the key functions in energy transmission, mechanical support and signal transmission of 3D chip. With the increasing of TSV interconnection density, the reliability of TSV is becoming increasingly prominent, and the slight variation of TSV dimension may exert severe impact on the fatigue life of the TSV array. In this study, a typical double-layer TSV interconnected 3D array is built to carried out the multi-interface fatigue analysis under thermoelectric structure coupling field, the influence of different dimension of the TSV interconnected array on the fatigue life of various interface and whole thermoelectric circuit are deeply investigated. Results shows that: 1) relatively small or large diameter of TSV-Cu or Bump can effectively improve the fatigue life of Bump-RDL interface. 2) The fatigue life of the top interface between TSV-Cu and SiO2 layer is slightly higher than that of the bottom interface. 3) The optimal dimension combination of TSV interconnected array is highly related with external working environment and own working state. Under the condition of this study, the dimension corresponding to Case 0 (TSV-Cu diameter: 5μ m, Bump diameter: 10μ m, Pitch: 100μ m, SiO2 layer thickness: 1μ m) is the optimal solution. 4) TSV-Cu diameter and SiO2 thickness have the greatest influence on the fatigue life of TSV array. Relevant results can provide valuable references for locating the weak points of the TSV interconnected array and the subsequent optimization design.Keywords
Funding Information
- National Natural Science Foundation of China (52275166)
- National Key Laboratory Fund (6142003202309)
- Opening Project of Science and Technology on Reliability Physics and Application Technology of Electronic Component Laboratory (6142806230303)
- Hunan graduate research innovation project (CX20230020)
- Youth Independent Innovation Science Fund of NUDT (ZK23-29)
This publication has 31 references indexed in Scilit:
- Fatigue behaviour analysis of thermal cyclic loading for through-silicon via structures based on backstress stored energy densityInternational Journal of Fatigue, 2023
- Experimental research on performance degradation of TSV microstructure under thermal cycling, vibration and electrical stressMicroelectronics Reliability, 2022
- Effects of multi-cracks and thermal-mechanical coupled load on the TSV reliabilityMicroelectronics Reliability, 2022
- Interfacial Laser‐Induced Graphene Enabling High‐Performance Liquid−Solid Triboelectric NanogeneratorAdvanced Materials, 2021
- Effects of anisotropy on the reliability of TSV microstructureMicroelectronics Reliability, 2020
- Research on fatigue of TSV-Cu under thermal and vibration coupled load based on numerical analysisMicroelectronics Reliability, 2020
- Effects of dimension parameters and defect on TSV thermal behavior for 3D IC packagingMicroelectronics Reliability, 2017
- Investigation of durability of TSV interconnect by numerical thermal fatigue analysisInternational Journal of Precision Engineering and Manufacturing, 2011
- Numerical analysis of thermo-mechanical reliability of through silicon vias (TSVs) and solder interconnects in 3-dimensional integrated circuitsMicroelectronic Engineering, 2010
- Thermal Stresses Analysis of 3-D Interconnect2009