Effect of Ultrasonic Treatment on Residual Stress and Mechanical Properties of AISI 304 Stainless Steel Welding
- 26 July 2024
- journal article
- research article
- Published by ASTM International in Journal of Testing and Evaluation
- Vol. 52 (5) , 2867-2882
Abstract
AISI 304 stainless steel has low thermal conductivity and a high linear expansion coefficient; conventional welding with this material produces coarse grains and poor joint tensile properties. To address the problems inherent in conventional 304 stainless steel welding, an ultrasonic transducer was brought into contact with a base metal and treated with ultrasonic vibration during welding. The residual stress distribution, microstructure, and mechanical properties of the welded joint were then analyzed. The results showed that under the combined action of thermodynamics and the dynamics caused by ultrasonic treatment, the flow performance of the molten pool was enhanced, heat was transferred from the high-temperature region to the low-temperature region, and the metal elements were constantly diffused during the crystallization of the molten pool. Thus, the transformation rate of columnar crystals to equiaxed crystals was accelerated, the proportion of equiaxed crystals increased, and the grains became refined. Compared with conventional welding, the microstructure of the 304 stainless steel welded joints was better after the introduction of ultrasonic vibration, and its tensile residual stress was significantly lower. The improvement in the microstructure of the weld improved its mechanical properties, and the hardness of the weld zone increased significantly, which was close to that of the base metal. After the ultrasonic treatment, the increase in the equiaxed crystals and the refinement in the grains effectively improved the quality of the welded joints so that the tensile strength of the welded joints was higher than that of conventional welded joints. Under the condition of the same ultrasonic vibration frequency and power, the tensile strength of welded joints with 2-mm steel plate exhibited a notable increase, which was 13 %.Keywords
Funding Information
- National Key Research and Development Program of China (2021YFF0600500)
- National Key Research and Development Program of China (2021YFF0600500)
This publication has 24 references indexed in Scilit:
- Microstructure evolution and mechanical properties in a gas tungsten arc welded Fe42Mn28Co10Cr15Si5 metastable high entropy alloyMaterials Science and Engineering: A, 2023
- Enhancement of Microstructural and Mechanical Properties of Ultrasonic Vibration-Assisted Cold Metal Transfer Welding of 304 Stainless SteelJournal of Materials Engineering and Performance, 2022
- Hall-Petch relationship in selective laser melting additively manufactured metals: using grain or cell size?Journal of Central South University, 2021
- Significance of Finite Element Models and Solid-State Phase Transformation on the Evaluation of Weld Induced Residual StressesMetals and Materials International, 2021
- Pitting Corrosion in AISI 304 Rolled Stainless Steel Welding at Different Deformation LevelsApplied Sciences, 2019
- Effects of Ultrasonic Nanocrystal Surface Modification on the Residual Stress, Microstructure, and Corrosion Resistance of 304 Stainless Steel WeldsMetallurgical and Materials Transactions A, 2018
- Improvement in accuracy of the measurements of residual stresses due to circumferential welds in thin-walled pipe using Rayleigh wave methodNuclear Engineering and Design, 2009
- Numerical and experimental investigations on welding residual stress in multi-pass butt-welded austenitic stainless steel pipeComputational Materials Science, 2008
- Residual stress modification by post-weld treatment and its beneficial effect on fatigue strength of welded structuresInternational Journal of Fatigue, 2003
- Modification of solidification structures by pulse electric discharging.ISIJ International, 1990