Size-Separated Sampling and Analysis of Isocyanates in Workplace Aerosols—Part II: Aging of Aerosols from Thermal Degradation of Polyurethane
Authors:
Open Access
- 30 April 2008
- journal article
- research article
- Published by Oxford University Press (OUP) in Annals of Occupational Hygiene
- Vol. 52 (5) , 375-383
Abstract
A new type of isocyanate sampler has been used to investigate aging aerosols generated during thermal degradation of polyurethane (PUR). The sampler consists of a denuder connected in series with a three-stage cascade impactor and a filter. The denuder collects gas-phase isocyanates. The three impactor stages had cut-off diameters (d50) of 2.5, 1.0 and 0.5 μm, respectively. The end filter collects particles <0.5 μm. For derivatization of isocyanates in the sampler, di-n-butylamine mixed with an equimolar amount of acetic acid was used for impregnation of the sampler stages. Consecutive sampling using three denuder–impactor samplers was performed in a test chamber, with a total sampling time of 9 min. Analysis of air samples was performed using liquid chromatography-mass spectrometry (LC-MS)/MS. Particle size measurements were performed using a scanning mobility particle sizer (SMPS). A time-dependent behavior was observed for aromatic diisocyanates during aging of the aerosol. Thermal degradation of different PUR materials showed different distribution of isocyanates between gas and particles. Aromatic diisocyanates (toluene diisocyanate (TDI) and methylene diphenyl diisocyanate) were initially in gas phase and associated to very small particles. After a few minutes most of these isocyanates were associated with particles <1 μm. Monoisocyanates and hexamethylene diisocyanate (HDI) were not found to be associated with particles.Keywords
This publication has 17 references indexed in Scilit:
- Size-Separated Sampling and Analysis of Isocyanates in Workplace Aerosols. Part I. Denuder—Cascade Impactor SamplerAnnals of Occupational Hygiene, 2008
- Determination of Airborne Isocyanates Generated During the Thermal Degradation of Car Paint in Body Repair ShopsAnnals of Occupational Hygiene, 2005
- Identification of the isocyanates generated during the thermal degradation of a polyurethane car paintJournal of Analytical and Applied Pyrolysis, 2004
- Determination of technical grade isocyanates used in the production of polyurethane plasticsJournal of Environmental Monitoring, 2004
- Determination of isocyanates, aminoisocyanates and amines in air formed during the thermal degradation of polyurethaneJournal of Environmental Monitoring, 2002
- Determination of isocyanic acid in airJournal of Environmental Monitoring, 2001
- Airborne thermal degradation products of polyurethane coatings in car repair shopsJournal of Environmental Monitoring, 2000
- Gas/Particle Partitioning of Organic Compounds to Environmental Tobacco Smoke: Partition Coefficient Measurements by Desorption and Comparison to Urban Particulate MaterialEnvironmental Science & Technology, 1996
- Respiratory and other hazards of isocyanatesInternational Archives of Occupational and Environmental Health, 1994
- WORKERS' EXPOSURE TO ISOCYANATESAIHA Journal, 1992