Analytical Study of a Pin-Loaded Hole in Unidirectional Laminated Composites With Triangular and Circular Fibers
- 25 January 2013
- journal article
- Published by Wiley in Journal of Applied Mechanics
- Vol. 80 (2) , 021018-0210187
Abstract
The problem of stress concentrations in the vicinity of pin-loaded holes is of particular importance in the design of multilayered composite structures made of triangular or circular glass fibers. It is assumed that all of the fibers in the laminate lie in one direction while loaded by a force p0 at infinity, parallel to the direction of the fibers. According to the shear lag model, equilibrium equations are derived for both types of fibers. A rectangular arrangement is postulated in either case. Upon the proper use of boundary and bondness conditions, stress fields are derived within the laminate, along with the surrounding pinhole. The analytical results are compared to those of the finite element values. A very good agreement is observed between the two methods. According to the results, composite structures made of triangular glass fibers result in lower values of stress concentrations around the pin, as opposed to those of circular glass fibers.Keywords
This publication has 14 references indexed in Scilit:
- On the stress distribution around the hole in mechanically fastened jointsMechanics Research Communications, 2009
- An FE analysis of the stresses in pultruded GRP single-bolt tension joints and their implications for joint designComputers & Structures, 2008
- Analytical study of a pin–loaded hole in elastic orthotropic platesComposite Structures, 2007
- A design methodology for mechanically fastened joints in laminated composite materialsComposites Science and Technology, 2006
- Mechanical behaviour of circular and triangular glass fibres and their compositesComposites Science and Technology, 2002
- Stress and failure analysis of mechanically fastened joints in composite laminatesComposite Structures, 2000
- Stresses around a pin-loaded hole in orthotropic plates with arbitrary loading directionComposite Structures, 1985
- A Finite Element Analysis of Single and Two-Hole Bolted Joints in Fibre Reinforced PlasticJournal of Composite Materials, 1981
- Stresses Around Pin-Loaded Holes in Elastically Orthotropic or Isotropic PlatesJournal of Composite Materials, 1977
- Failure Mode and Strength Predictions of Anisotropic Bolt Bearing SpecimensJournal of Composite Materials, 1971