Fatigue life of high-strength additively manufactured aluminium Al2139
Open Access
- 15 October 2025
- journal article
- research article
- Published by Springer Nature in Progress in Additive Manufacturing
- Vol. 11 (1) , 981-997
Abstract
The area of additively manufactured aluminium has so far been dominated by low-strength alloys such as AlSi10Mg even though several high-strength aluminium alloys have been developed in recent years. In this study, the fatigue life of the new additively manufactured high-strength aluminium alloy Al2139 was investigated and benchmarked against additively manufactured AlSi10Mg. The effect of geometrical notches and surface roughness on fatigue life was compared including roughness of down-skin areas. The Al2139 specimens showed superior fatigue strength in the machined condition, but AlSi10Mg had higher fatigue strength when comparing specimens with as-built surface. The latter results, although Al2139 had almost twice the tensile strength, showed that the difference in fatigue strength for specimens with as-built surface was mainly attributed to the rougher surface of the Al2139 specimens which had up to 4 times higher surface roughness for vertical areas and up to 10 times higher surface roughness in down-skin areas compared to AlSi10Mg specimens.Keywords
Funding Information
- Swedish Innovation Agency VINNOVA (2020-04266)
- Linköping University
This publication has 42 references indexed in Scilit:
- Review on the correlation between microstructure and mechanical performance for laser powder bed fusion AlSi10MgAdditive Manufacturing, 2022
- Effect of process parameters and grain refinement on hot tearing susceptibility of high strength aluminum alloy 2139 in laser powder bed fusionProgress in Additive Manufacturing, 2022
- Impact of Print Orientation on Morphological and Mechanical Properties of L-PBF Based AlSi7Mg Parts for Aerospace ApplicationsSilicon, 2021
- Selective laser melting additive manufacturing of 7xxx series Al-Zn-Mg-Cu alloy: Cracking elimination by co-incorporation of Si and TiB2Additive Manufacturing, 2020
- INFLUENCE OF ROUGH AS-BUILT SURFACES ON SMOOTH AND NOTCHED FATIGUE BEHAVIOR OF L-PBF AlSi10MgAdditive Manufacturing, 2020
- Anisotropy of additively manufactured AlSi10Mg: threads and surface integrityThe International Journal of Advanced Manufacturing Technology, 2020
- Fatigue behaviour of notched additive manufactured Ti6Al4V with as-built surfacesInternational Journal of Fatigue, 2017
- Fatigue performance of additive manufactured TiAl6V4 using electron and laser beam meltingInternational Journal of Fatigue, 2017
- Anisotropic high cycle fatigue behavior of Ti–6Al–4V obtained by powder bed laser fusionInternational Journal of Fatigue, 2017
- A selective laser melting and solution heat treatment refined Al–12Si alloy with a controllable ultrafine eutectic microstructure and 25% tensile ductilityActa Materialia, 2015