Fatigue Resistance of an Anodized and Hardanodized 6082 Aluminum Alloy Depending on the Coating Thickness in the High Cycle Regime
Open Access
- 30 August 2023
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 25 (20)
Abstract
In this study, the high cycle fatigue behavior of an anodized 6082 aluminum alloy is investigated. Main focus is on the most relevant influencing factors for crack initiation and propagation under cyclic loading and damage mechanisms considering coating type, thickness, and residual stresses. The bare substrate is compared to anodized and hardanodized specimens with three coating thicknesses, for each coating type, in the range from 20 to 70 μm. Coating hardness and microstructure as well as residual stresses are analyzed. Fatigue and fracture behavior under alternating tension–compression loading is determined. Dependent on the coating thickness, the fatigue strength is reduced by 8%–50% after anodizing and by 50%–62% after hardanodizing. As the coating thickness is equal to the initial crack length from a fracture mechanical point of view, stress intensities at the crack tips are higher for thicker coatings respectively longer initial crack lengths. Therefore, propagation of fatigue‐induced cracks from the coating into the substrate is promoted for a higher coating thickness resulting in premature failure. A significant correlation between the coating thickness and tensile residual stresses induced by both coatings in the subjacent substrate is not found and residual stress influence on the overall fatigue strength is only minor.Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (435265960)
This publication has 43 references indexed in Scilit:
- The effect of anodic oxide coating on the fatigue behaviour of AA6082 with an ultrafine‐grained microstructureMaterialwissenschaft und Werkstofftechnik, 2011
- Einfluss der Mikrostruktur auf das Verschleiß‐ verhalten der hartanodisierten Aluminium‐legierungen EN AW‐6082 und EN AW‐7075Materialwissenschaft und Werkstofftechnik, 2009
- Effect of anodic oxidation on fatigue performance of 7075-T6 alloySurface and Coatings Technology, 2008
- Influence of microarc oxidation and hard anodizing on plain fatigue and fretting fatigue behaviour of Al–Mg–Si alloySurface and Coatings Technology, 2008
- Coating residual stress effects on fatigue performance of 7050-T7451 aluminum alloySurface and Coatings Technology, 2007
- Influence of anodization on the fatigue strength of 7050‐T7451 aluminium alloyFatigue & Fracture of Engineering Materials & Structures, 2007
- The effect of oxide coatings on fatigue properties of 7475-T6 aluminium alloySurface and Coatings Technology, 2007
- S‐N‐P curves in 7075 T7351 and 2024 T3 aluminium alloys subjected to surface treatmentsFatigue & Fracture of Engineering Materials & Structures, 2007
- Influence of the anodizing temperature on the porosity and the mechanical properties of the porous anodic oxide filmSurface and Coatings Technology, 2007
- Fatigue cracking in materials with brittle surface coatingsScripta Metallurgica et Materialia, 1993