Digitally Tuned Multidirectional All-Polyethylene Composites via Controlled 1D Nanostructure Formation during Extrusion-Based 3D Printing
- 2 March 2021
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 3 (3) , 1675-1686
Abstract
No abstract availableKeywords
Funding Information
- European Regional Development Fund
- Sustainability Center Freiburg, Germany
This publication has 53 references indexed in Scilit:
- Tailoring Hydrocarbon Polymers and All‐Hydrocarbon Composites for Circular EconomyMacromolecular Rapid Communications, 2018
- Silica Nanofoam (NF) Supported Single- and Dual-Site Catalysts for Ethylene Polymerization with Morphology Control and Tailored Bimodal Molar Mass DistributionsMacromolecules, 2013
- Self-reinforced polymeric materials: A reviewProgress in Polymer Science, 2010
- Sustainability Metrics: Life Cycle Assessment and Green Design in PolymersEnvironmental Science & Technology, 2010
- The Ethylene Polymerization with Ziegler Catalysts: Fifty Years after the DiscoveryAngewandte Chemie International Edition, 2003
- An investigation on rheological and impact behaviour of high density and ultra high molecular weight polyethylene mixturesEuropean Polymer Journal, 1997
- Conformational relaxation time in polymer solutions by elongational flow experiments: 2. Preliminaries of further developments: chain retraction; identification of molecular weight fractions in a mixturePolymer, 1980
- A study of the chain extending effect of elongational flow in polymer solutionsColloid and Polymer Science, 1978
- The concept of one polymer composites modelled with high density polyethyleneJournal of Materials Science, 1975
- Some macroscopic properties of stirring-induced crystals of polyethyleneJournal of Macromolecular Science, Part B, 1972