Effect of production conditions on structural properties of refractory materials
Authors:
- 1 February 2011
- journal article
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 15 (1) , 47-52
Abstract
Structural properties, such as apparent density, true density, porosity and shrinkage of resin bonded bauxite specimens, were measured. Different bauxite grain sizes, resin contents, moulding pressures and firing temperatures were selected for preparing the specimens. Simple mathematical models were used to correlate the examined properties as functions of production conditions and materials' characteristics. The proposed models were fitted on the experimental data and parameters were estimated. After data analysis, it was found that low porosity specimens are produced using high materials grain size and moulding pressure, along with firing at higher temperatures. True density did not appear to indicate significant changes for all the above parameters. Shrinkage is mainly affected by firing temperature but does not depend on moulding pressure. Increase in firing temperature increases shrinkage due to higher sintering, while high grain size leads to specimens with low shrinkage. Finally, SEM was used to observe the above mentioned phenomena. © W. S. Maney & Son Ltd. 2011Keywords
This publication has 13 references indexed in Scilit:
- Refractory Materials2007
- The effect of additives on the properties and microstructures of Al2O3-C refractoriesJournal of Materials Science, 2006
- Effects of resin and graphite content on density and oxidation behavior of MgO-C refractory bricksCeramics International, 2006
- Microstructure and Phase Analysis of Ethyl Silicate-Bonded Alumina-Zircon RefractoriesRefractories and Industrial Ceramics, 2005
- Effect of grain size on elastic modulus and hardness of nanocrystalline ZrO2-3 wt% Y2O3 ceramicJournal of Materials Science, 2004
- EFFECT OF DRYING METHOD ON SHRINKAGE AND POROSITYDrying Technology, 1997
- Influence of the type of alumina and additives on the properties of corundum heat-insulating refractoryRefractories and Industrial Ceramics, 1987
- Reduction of linear shrinkage in glass-fiber refractories during serviceRefractories and Industrial Ceramics, 1983
- CERAMIC ABSTRACTSJournal of the American Ceramic Society, 1965
- SHRINKAGE RATES IN FIRING FIRE‐CLAY REFRACTORIES*Journal of the American Ceramic Society, 1947