Shear Strengthening of Reinforced Concrete T-Beams with Anchored CFRP Laminates
Authors:
- 1 August 2021
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Composites for Construction
- Vol. 25 (4) , 04021030
Abstract
Strengthening of existing reinforced concrete (RC) structures by externally bonding carbon fiber–reinforced polymers (CFRP) applied to the concrete substrate has proven to be effective in enhancing the shear capacity of RC beams. However, a premature debonding of CFRP laminates does not allow a full utilization of the strength of laminates. This paper reports on a research program that aimed at studying the effect of anchoring CFRP sheets used for shear strengthening using CFRP splay anchors. The anchors were used to further improve the shear strength contribution of FRP by delaying debonding and achieving a higher strain in the external CFRP reinforcement. A total of nine shear-deficient T-beams were cast and externally strengthened with high-modulus CFRP laminates in the form of U-wraps and anchored with different configurations of high-modulus CFRP splay anchors. The variables considered for the experimental program included anchor embedment depth and anchor splay length. In addition, the effect of installing the anchors directly on the concrete substrate prior to installing the U-wraps was investigated. The performance of the anchored U-wrapped specimens in terms of failure modes, load–deflection responses, and shear strength and strain in CFRP laminates was compared with that of unstrengthened and unanchored strengthened control specimens. The test results showed that high-modulus CFRP anchors delayed the debonding of the U-wraps and significantly improved the shear strength and ductility of the beam specimens. It was also concluded that anchoring CFRP U-wrap shear reinforcement by properly designed CFRP anchors allows for a higher strain to be attained in the CFRP laminates. A comparison between the experimental capacities of the tested specimens with the theoretical values predicted using current standards provides reasonable predictions on the shear capacity of anchored specimens.Keywords
This publication has 36 references indexed in Scilit:
- Use of Anchors in Shear Strengthening of Reinforced Concrete T-Beams with FRPJournal of Composites for Construction, 2013
- Influence of FRP anchor fan configuration and dowel angle on anchoring FRP platesComposites Part B: Engineering, 2012
- Shear Behavior of Reinforced Ultrahigh Toughness Cementitious Composite Beams without Transverse ReinforcementJournal of Materials in Civil Engineering, 2012
- Optimisation of carbon and glass FRP anchor designConstruction and Building Materials, 2012
- Performance of End-Anchorage Systems for RC Beams Strengthened in Shear with Epoxy-Bonded FRPJournal of Composites for Construction, 2012
- Experimental Behavior of Carbon Fiber-Reinforced Polymer (CFRP) Sheets Attached to Concrete Surfaces Using CFRP AnchorsJournal of Composites for Construction, 2010
- Behaviour of Handmade FRP Anchors under Tensile Load in Uncracked ConcreteAdvances in Structural Engineering, 2009
- Tensile Behavior of FRP Anchors in ConcreteJournal of Composites for Construction, 2009
- Debonding strength and anchorage devices for reinforced concrete elements strengthened with FRP sheetsComposites Part B: Engineering, 2008
- Shear Capacity of Fiber-Reinforced Polymer-Strengthened Reinforced Concrete Beams: Fiber Reinforced Polymer RuptureJournal of Structural Engineering, 2003