O3-TEOS CVD Film Formation on Thermal SiO2Pre-Coated with Ethanol
- 1 January 2012
- journal article
- Published by The Electrochemical Society in ECS Journal of Solid State Science and Technology
- Vol. 1 (5) , N73-N78
Abstract
We previously reported that organic solvent (ethanol) treatment of a film formed by plasma enhanced chemical vapor deposition (PE-CVD) remarkably improved the gap-filling property of O3-tetraethylorthosilicate (O3-TEOS) atmospheric pressure chemical vapor deposition (AP-CVD) film. Based on these results, we concluded that alkoxy (ethoxy) groups, which are generated by ethanol treatment, reduced the adsorptive activities of the sites distributed on the surface, causing a decrease in the sticking probability of vapor-phase species responsible for the deposition. However, an opposite hypothesis has been reported, which proposes that ethoxy groups become adsorption sites. In this study, we offer a counterargument and clarify that ethoxy groups, which were generated by ethanol treatment following light etching using dilute hydrofluoric acid (HF), do not become adsorption sites on the surface of thermally grown silicon dioxide (thermal SiO2) during O3-TEOS film deposition, since the O3-TEOS film was formed at a low deposition rate (DR). A smooth surface and excellent gap-filling into the patterns covered with thermal SiO2 were observed on the O3-TEOS film formation by ethanol treatment. We propose that a degasification step during O3-TEOS film formation or during annealing after the deposition could be closely related to improved surface roughness and gap-filling.Keywords
This publication has 40 references indexed in Scilit:
- A Mechanism for Increasing Growth Rate of Undoped SACVD FilmECS Transactions, 2010
- SiO[sub 2] Films Deposited by APCVD with a TEOS/Ozone Mixture and Its Application to the Gate Dielectric of TFTsJournal of the Electrochemical Society, 2010
- A Conformal Oxide Liner for Through Silicon Vias by Pulsed SA-CVD DepositionECS Transactions, 2009
- Effect of SC-1 Treatment in Thermal Wall Oxide on Nanoscale STI Gap-Filling by O3/TEOS CVDSolid State Phenomena, 2007
- Trench filling characteristics of low stress TEOS/ozone oxide deposited by PECVD and SACVDMicrosystem Technologies, 2004
- Deoxidization of Water Desorbed from APCVD TEOS-O[sub 3] SiO[sub 2] Film with Thin Titanium Cap FilmJournal of the Electrochemical Society, 2004
- Electrical Properties of Bulk Silicon Dioxide and SiO[sub 2]/Si Interface Formed by Tetraethylorthosilicate-Ozone Chemical Vapor DepositionJournal of the Electrochemical Society, 2000
- Thermal desorption spectra of SiO2 films deposited on Si and on thermal SiO2 by tetraethylorthosilicate/O3 atmospheric-pressure chemical vapor depositionJournal of Applied Physics, 1999
- Subatmospheric chemical vapor deposition ozone/TEOS process for SiO2 trench fillingJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1995
- Silicon Dioxide Deposition by Atmospheric Pressure and Low‐Temperature CVD Using TEOS and OzoneJournal of the Electrochemical Society, 1990