Analog AGC Circuitry for a CMOS WLAN Receiver
Authors:
- O. JeonOJO. Jeon
- R.M. FoxRFR.M. Fox
- B.A. MyersBMB.A. Myers
- 18 September 2006
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 41 (10) , 2291-2300
Abstract
The IEEE 802.11a standard uses orthogonal frequency division multiplexing (OFDM) to allow high data rates in multipath WLAN environments. The high peak-to-average power ratio (PAPR) of OFDM signals, along with stringent settling-time constraints, make conventional closed-loop automatic gain control (AGC) schemes impractical for WLAN receivers. In a direct conversion receiver, AGC and channel-select filtering are performed by analog baseband circuitry. A baseband signal processor using a new open-loop analog gain-control algorithm for OFDM is described. The new AGC algorithm uses switched coarse gain-setting steps followed by an analog open-loop fine gain-setting step to set the final gain of variable gain amplifiers (VGAs). The AGC was implemented in a 0.18-mum CMOS process using newly designed circuits including linear VGAs, RMS detectors, and current-mode computation circuitry. Simulation and measurement results verify that the new AGC circuit converges with gain error less than 1dB to the desired level within 5.6 musKeywords
This publication has 6 references indexed in Scilit:
- The flipped voltage follower: a useful cell for low-voltage low-power circuit designIEEE Transactions on Circuits and Systems I: Regular Papers, 2005
- A 5-GHz CMOS transceiver for IEEE 802.11a wireless LAN systemsIEEE Journal of Solid-State Circuits, 2002
- Multiple operating points in a CMOS log-domain filterIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 1999
- On the design of constant settling time AGC circuitsIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 1998
- CMOS transconductance multipliers: a tutorialIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 1998
- A wide range differential difference amplifier: a basic block for analog signal processing in MOS technologyIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 1993