Stress Evolution Related to Metal Routing in Submicron Multilevel Interconnects: Void and Extrusion
Authors:
- 27 November 2007
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components and Packaging Technologies
- Vol. 30 (4) , 724-730
Abstract
Failure mechanism of submicron multilevel interconnects encapsulated in a quad flat package subjected to high temperature operating life (HTOL) test under temperature and bias has been investigated. With the presence of void formation in the upper metal, Al extrudes from the lower metal to the adjacent metal lines leading to a fatal short failure. Void itself is not critical but later the growth of extrusion compromises the integrity and circuit reliability. Such a failure mechanism is explained with stress evolution on the metal routing associated with tensile stress imposed on the upper metal adhered to a thicker interlayer dielectric on certain points then relived with void formation that triggers compressive stress on the lower metal layer causing Al extrusion. For the purpose of verification, a new layout of the metal routing is committed and subjected to the HTOL. We found that the aspect ratio of the metal line significantly influences the integrity of submicron multilevel interconnects.Keywords
This publication has 15 references indexed in Scilit:
- Mechanical stress measurements in damascene copper interconnects and influence on electromigration parameters2003
- Thermal stresses in L and T shaped metal interconnects: a three dimensional analysis2003
- A high performance and reliable low-k inter-metal dielectric using hydrogen silsesquioxane (HSQ)2003
- Integration of fluorine-doped silicon oxide in copper pilot line for 0.12-μm technologyMicroelectronic Engineering, 2002
- Analysis of thermal stresses in metal interconnects with multilevel structuresMicroelectronics Reliability, 2001
- Investigation of the thermal stress field in a multilevel aluminium metallisation in VLSI systemsMicroelectronics Reliability, 2000
- The effects of the stress dependence of atomic diffusivity on stress evolution due to electromigrationJournal of Applied Physics, 1997
- Change of the failure mode of layered aluminum conductors by modification of overlying dielectric1994
- Stress evolution due to electromigration in confined metal linesJournal of Applied Physics, 1993
- Electromigration-Induced Compressive Stresses in Encapsuiated Thin-Film Conductors1991