Methylene blue removal with ZnO coated montmorillonite: thermodynamic, kinetic, isotherm and artificial intelligence studies
Authors:
- 7 October 2021
- journal article
- research article
- Published by Taylor & Francis in International Journal of Phytoremediation
- Vol. 24 (8) , 867-880
Abstract
In this study, montmorillonite clay was coated with zinc oxide (ZnO) nanoparticles. The study’s primary aim is to investigate the adsorption properties of zinc oxide coated montmorillonite adsorbent against methylene blue (MB), and determine ZnO's effectiveness in adsorption. First, the surface properties of the ZnO-coated montmorillonite (ZnO/MMT) adsorbent were determined by FTIR Spectroscopy, XRD, and SEM/EDS. In the adsorption studies, the effects of different parameters such as contact time (5–150 min), adsorbent dosage (0.05–0.5 g), initial concentration (50–200 mg/L), temperature (298–318 K), and initial pH (4–12) were investigated. In addition, a fuzzy model was developed by using adsorption parameters so that the removal rates could be calculated more quickly. Adsorption kinetics and equilibrium results were explained by the pseudo-second-order model and the Langmuir isotherm model, respectively. The highest adsorption capacity was calculated as 384.62 mg/g at 318 K. The enthalpy value was calculated as 2.16 kJ/mol. The entropy value was calculated as 0.04 kJ/mol K. The negative entropy value in the thermodynamic parameters calculated at all temperatures shows that the adsorption was spontaneous. According to the data we obtained, ZnO/MMT nanoparticles can be successfully applied for MB removal from aqueous solutions. Due to its advantages such as high removal efficiency, ease of use and adsorbent recovery, the use of montmorillonite mineral (MMT) for the removal of dyestuffs in water has become widespread. But, up to the best of our knowledge, the role of ZnO in a composite of ZnO/MMT has not been reported for the removal of MB. To eliminate this deficiency, we first obtained a zinc oxide-coated montmorillonite (ZnO/MMT) adsorbent in our study. As an effective material for the adsorption of organic pollutants, a fuzzy model with an abundant, available and, low-cost Zinc oxide coated montmorillonite adsorbent was used for the first time. It has been observed that the adsorption level is comparable with some other materials previously studied in the literature.Keywords
This publication has 51 references indexed in Scilit:
- Fabrication and characterization of Fe@MoPO nanoparticles: Ion exchange behavior and photocatalytic activity against malachite greenJournal of Molecular Liquids, 2016
- Adsorption of cationic and anionic azo dyes on sepiolite clay: Equilibrium and kinetic studies in batch modeJournal of Environmental Chemical Engineering, 2016
- Adsorption of malachite green and crystal violet cationic dyes from aqueous solution using pumice stone as a low-cost adsorbent: kinetic, equilibrium, and thermodynamic studiesDesalination and Water Treatment, 2016
- Comparison of Moringa stenopetala seed extract as a clean coagulant with Alum and Moringa stenopetala-Alum hybrid coagulant to remove direct dye from Textile WastewaterEnvironmental Science and Pollution Research, 2016
- Modeling of Reactive Blue 19 azo dye removal from colored textile wastewater using L-arginine-functionalized Fe3O4 nanoparticles: Optimization, reusability, kinetic and equilibrium studiesJournal of Magnetism and Magnetic Materials, 2016
- Optimization of methylene blue adsorption by pumice powderAdvances in environmental research, 2016
- Synthesis and characterization of montmorillonite clay intercalated with molecular magnetic compoundsJournal of Solid State Chemistry, 2015
- Removal of model cationic dye by adsorption onto poly(methacrylic acid)/zeolite hydrogel composites: Kinetics, equilibrium study and image analysisSeparation and Purification Technology, 2014
- Enzymatic Treatment and Detoxification of Acid Orange 7 from Textile WastewaterApplied Biochemistry and Biotechnology, 2011
- Kinetics of adsorption of metal ions on inorganic materials: A reviewAdvances in Colloid and Interface Science, 2011