Study of the Effect of L-PBF Technique Temporal Evolution on Microstructure, Surface Texture, and Fatigue Performance of Ti gr. 23 Alloy
Open Access
Abstract
Titanium alloys are widely used in various technological fields due to their excellent performance. Since the early stages of the 3D printing concept, these alloys have been intensively used as materials for these processes. In this work, the evolution of the performance of the 3D printing process has been studied by analysing the microstructure and the mechanical properties, fatigue and tensile, of the Ti gr. 23 alloy produced by two different models of Concept Laser M2 Cusing machines (an old model and a more recent one). The process parameters recommended by the manufacturer were adopted for each machine. Both microstructural and surface texture characterisations were carried out to better correlate the differences with the production process technique. For the same purpose, tensile tests and microhardness profiles were obtained, while the dynamic mechanical properties were evaluated by means of fatigue tests aimed at determining the fatigue limit of the material using a staircase approach. The mechanical tests were carried out on specimens with three different orientations with respect to the building platform, using two different SLM techniques. The fatigue behaviour was then analysed by evaluating the fracture surfaces and, in particular, the crack nucleation sites. By comparing the calculated fatigue values with the results of local fatigue calculations, an estimate of the residual stresses near the crack nucleation site was obtained. The results showed that the specimens produced on a newer machine had lower roughness (about 10%), slightly higher ductility, and a higher fatigue limit (10–20 MPa) compared to the specimens produced with the same material but on older equipment.Keywords
Funding Information
- European Union Next-Generation EU (ECS00000043)
This publication has 44 references indexed in Scilit:
- Is the energy density a reliable parameter for materials synthesis by selective laser melting?Materials Research Letters, 2017
- Microstructure and mechanical properties investigation of CP titanium processed by selective laser melting (SLM)Journal of Materials Processing Technology, 2017
- On the limitations of Volumetric Energy Density as a design parameter for Selective Laser MeltingMaterials & Design, 2017
- Anisotropic high cycle fatigue behavior of Ti–6Al–4V obtained by powder bed laser fusionInternational Journal of Fatigue, 2017
- An approach for the thermal analysis of internal combustion engines’ exhaust valvesApplied Thermal Engineering, 2016
- Influence of defects on mechanical properties of Ti–6Al–4V components produced by selective laser melting and electron beam meltingMaterials & Design, 2015
- Effect of Powder Particle Shape on the Properties of In Situ Ti–TiB Composite Materials Produced by Selective Laser MeltingJournal of Materials Science & Technology, 2015
- Effect of the build orientation on the mechanical properties and fracture modes of SLM Ti–6Al–4VMaterials Science and Engineering: A, 2014
- Effect of microstructure on fatigue properties of WC-Co hard metalsProcedia Engineering, 2010
- Estimating the fatigue stress concentration factor of machined surfacesInternational Journal of Fatigue, 2002