Influence analysis of gap distance between single-mode fiber and transition edge single-photon sensors
Authors:
- 9 September 2021
- conference paper
- Published by SPIE-Intl Soc Optical Eng
- Vol. 11909, 28-33
Abstract
Optical transition-edge sensor (TES) with high quantum efficiency, low dark count rate, and high energy resolution has been used in quantum information and communications. The gap distance between the fiber tip and TES has an influence on the TES performance. Here we measured the interference pattern of our optical TES devices with and without anti-reflection coating and obtain the gap distance. We also obtain the absolute reflectivity of the Ti-TESs by correcting the effect of power splitter and circulator. Our copper block shrinks ~10 μm when cooled from room temperature down to 100 mK. The measured reflectivity is consistent with the simulation taking the dielectric mirror, Ti film and anti-reflection coating into account. In addition, we study the gap distance dependence of the system efficiency, and find that it is in good agreement with the measured reflectivity at 100 mK. These analyses are useful for further improvement of TES packaging.Keywords
This publication has 7 references indexed in Scilit:
- Experimental quantum data lockingPhysical Review A, 2016
- Titanium-based transition-edge photon number resolving detector with 98% detection efficiency with index-matched small-gap fiber couplingOptics Express, 2011
- Photon-Number-Resolution at Telecom Wavelength with Superconducting Nanowires2010
- Counting near-infrared single-photons with 95% efficiencyOptics Express, 2008
- Performance of photon-number resolving transition-edge sensors with integrated 1550 nm resonant cavitiesIEEE Transactions on Applied Superconductivity, 2005
- General transfer-matrix method for optical multilayer systems with coherent, partially coherent, and incoherent interferenceApplied Optics, 2002
- Optical coherence tomography (OCT): a reviewIEEE Journal of Selected Topics in Quantum Electronics, 1999