Predicting permeability from the characteristic relaxation time and intrinsic formation factor of complex conductivity spectra
Open Access
- 24 July 2015
- journal article
- research article
- Published by American Geophysical Union (AGU) in Water Resources Research
- Vol. 51 (8) , 6672-6700
Abstract
Low‐frequency quadrature conductivity spectra of siliclastic materials exhibit typically a characteristic relaxation time, which either corresponds to the peak frequency of the phase or the quadrature conductivity or a typical corner frequency, at which the quadrature conductivity starts to decrease rapidly toward lower frequencies. This characteristic relaxation time can be combined with the (intrinsic) formation factor and a diffusion coefficient to predict the permeability to flow of porous materials at saturation. The intrinsic formation factor can either be determined at several salinities using an electrical conductivity model or at a single salinity using a relationship between the surface and quadrature conductivities. The diffusion coefficient entering into the relationship between the permeability, the characteristic relaxation time, and the formation factor takes only two distinct values for isothermal conditions. For pure silica, the diffusion coefficient of cations, like sodium or potassium, in the Stern layer is equal to the diffusion coefficient of these ions in the bulk pore water, indicating weak sorption of these couterions. For clayey materials and clean sands and sandstones whose surface have been exposed to alumina (possibly iron), the diffusion coefficient of the cations in the Stern layer appears to be 350 times smaller than the diffusion coefficient of the same cations in the pore water. These values are consistent with the values of the ionic mobilities used to determine the amplitude of the low and high‐frequency quadrature conductivities and surface conductivity. The database used to test the model comprises a total of 202 samples. Our analysis reveals that permeability prediction with the proposed model is usually within an order of magnitude from the measured value above 0.1 mD. We also discuss the relationship between the different time constants that have been considered in previous works as characteristic relaxation time, including the mean relaxation time obtained from a Debye decomposition of the spectra and the Cole‐Cole time constant.Keywords
Funding Information
- Office of Science (BER)
- U.S. Department of Energy (DE-FG02-08ER646559)
This publication has 80 references indexed in Scilit:
- On the use of the Cole–Cole equations in spectral induced polarizationGeophysical Journal International, 2013
- Effective conductivity and permittivity of unsaturated porous materials in the frequency range 1 mHz–1GHzWater Resources Research, 2013
- The influence of aluminium on the dissolution of amorphous silica and its relation to alkali silica reactionCement and Concrete Research, 2012
- Spectral induced polarization measurements on variably saturated sand‐clay mixturesNear Surface Geophysics, 2012
- Spectral induced polarization of shaly sands: Influence of the electrical double layerWater Resources Research, 2012
- Direct estimation of the distribution of relaxation times from induced‐polarization spectra using a Fourier transform analysisNear Surface Geophysics, 2012
- Induced polarization signatures of cations exhibiting differential sorption behaviors in saturated sandsWater Resources Research, 2011
- Determining pore‐throat size in Permo‐Triassic sandstones from low‐frequency electrical spectroscopyGeophysical Research Letters, 2003
- Electrical‐hydraulic relationships observed for unconsolidated sedimentsWater Resources Research, 2002
- Theoretical and experimental study of time domain-induced polarization in water-saturated sandsJournal of Applied Geophysics, 2002