Temperature-dependent thermal diffusivity of the Earth’s crust and implications for magmatism
Top Cited Papers
- 19 March 2009
- journal article
- Published by Springer Nature in Nature
- Vol. 458 (7236) , 319-321
Abstract
The thermal evolution of planetary crust and lithosphere is largely governed by the rate of heat transfer by conduction. The governing physical properties are thermal diffusivity (kappa) and conductivity (k = kapparhoC(P)), where rho denotes density and C(P) denotes specific heat capacity at constant pressure. Although for crustal rocks both kappa and k decrease above ambient temperature, most thermal models of the Earth's lithosphere assume constant values for kappa ( approximately 1 mm(2) s(-1)) and/or k ( approximately 3 to 5 W m(-1) K(-1)) owing to the large experimental uncertainties associated with conventional contact methods at high temperatures. Recent advances in laser-flash analysis permit accurate (+/-2 per cent) measurements on minerals and rocks to geologically relevant temperatures. Here we provide data from laser-flash analysis for three different crustal rock types, showing that kappa strongly decreases from 1.5-2.5 mm(2) s(-1) at ambient conditions, approaching 0.5 mm(2) s(-1) at mid-crustal temperatures. The latter value is approximately half that commonly assumed, and hot middle to lower crust is therefore a much more effective thermal insulator than previously thought. Above the quartz alpha-beta phase transition, crustal kappa is nearly independent of temperature, and similar to that of mantle materials. Calculated values of k indicate that its negative dependence on temperature is smaller than that of kappa, owing to the increase of C(P) with increasing temperature, but k also diminishes by 50 per cent from the surface to the quartz alpha-beta transition. We present models of lithospheric thermal evolution during continental collision and demonstrate that the temperature dependence of kappa and C(P) leads to positive feedback between strain heating in shear zones and more efficient thermal insulation, removing the requirement for unusually high radiogenic heat production to achieve crustal melting temperatures. Positive feedback between heating, increased thermal insulation and partial melting is predicted to occur in many tectonic settings, and in both the crust and the mantle, facilitating crustal reworking and planetary differentiation.Keywords
This publication has 26 references indexed in Scilit:
- Thermal diffusivity of clinopyroxenes at elevated temperatureEuropean Journal of Mineralogy, 2008
- Temperature dependence of the relationship of thermal diffusivity versus thermal conductivity for crystalline rocksInternational Journal of Earth Sciences, 2007
- Differences between Archean and Proterozoic lithospheres: Assessment of the possible major role of thermal conductivityGeochemistry, Geophysics, Geosystems, 2006
- Petrologic and thermal constraints on the origin of leucogranites in collisional orogensEarth and Environmental Science Transactions of the Royal Society of Edinburgh, 2004
- Influence of temperature on thermal conductivity, thermal capacity and thermal diffusivity for different types of rockPhysics and Chemistry of the Earth, Parts A/B/C, 2003
- Crustal anatexis and its relation to the exhumation of collisional orogenic belts, with particular reference to the HimalayaMineralogical Magazine, 2002
- Experimental Constraints on Himalayan AnatexisJournal of Petrology, 1998
- Barrovian regional metamorphism: where’s the heat?Geological Society, London, Special Publications, 1998
- Crustal shortening and Eocene extension in the southeastern Canadian Cordillera: Some thermal and rheological considerationsTectonics, 1993
- The Breeding of Animals at Woods Hole During the Month of September, 1898Science, 1899