Evaluation of the Mixing Performance of the Micromixers With Grooved or Obstructed Channels
Authors:
- 25 June 2008
- journal article
- Published by ASME International in Journal of Fluids Engineering
- Vol. 130 (7) , 071102
Abstract
The mixing flows in microchannels were examined using numerical methods. To speed up fluid mixing, it is essential to generate lateral transport of mass. In this study, the mixing flow is disrupted by either placing grooves or block obstacles on the walls of the channels. Since the grooves or the blocks appear in a periodic configuration, the velocity is solved only in a section of the channel. With the repeating cycle of flow velocity field, the fluid concentration can be calculated throughout the entire length of the channel. Good agreement with experiments in the mixing performance justifies the present methodology. Two different channel configurations are under consideration: grooved channels and obstructed channels. The results reveal that with straight grooves, a well organized vortex flow is formed in the vertical plane along the groove, which leads to a helical flow in the channel. The mixing performance can be enhanced by having grooves on both the top and the bottom walls arranged in a staggered manner, by which the transversal velocity is largely increased. It is seen that the strength of the secondary flow and, thus, the mixing can be improved by suitably choosing geometric parameters of the groove, such as the depth, the width, and the oblique angle. It is also shown that the efficient mixing for the staggered herringbone type groove is due to the fluid stratification caused by the exchange of position of the resulted counter-rotating vortices. As for the obstructed channels, the flows are in essence two dimensional. Very strong transversal velocity can be produced by narrowing down the flow passage in the channel. However, the efficient mixing is obtained at the cost of large pressure head loss.Keywords
This publication has 33 references indexed in Scilit:
- Chaotic mixing on a micromixer with barriers embeddedChaos, Solitons & Fractals, 2007
- A passive planar micromixer with obstructions for mixing at low Reynolds numbersJournal of Micromechanics and Microengineering, 2007
- A Pressure-Correction Method for Incompressible Flows Using Unstructured MeshesNumerical Heat Transfer, Part B: Fundamentals, 2006
- Recirculating, passive micromixer with a novel sawtooth structureLab on a Chip, 2005
- Two-fluid mixing in a microchannelInternational Journal of Heat and Fluid Flow, 2004
- A barrier embedded chaotic micromixerJournal of Micromechanics and Microengineering, 2004
- A plug and play microfluidic deviceElectronic supplementary information (ESI) available: mpg files showing flow patterns. See http://www.rsc.org/suppdata/lc/b3/b301410j/Lab on a Chip, 2003
- Optimizing layout of obstacles for enhanced mixing in microchannelsSmart Materials and Structures, 2002
- Numerical Prediction of Flow and Heat Transfer in a Parallel Plate Channel With Staggered FinsJournal of Heat Transfer, 1987
- Fully Developed Flow and Heat Transfer in Ducts Having Streamwise-Periodic Variations of Cross-Sectional AreaJournal of Heat Transfer, 1977