Three‐dimensional assessment on digital cast of spontaneous upper first molar distorotation after Ni‐ti leaf springs expander and rapid maxillary expander: A two‐centre randomized controlled trial
Open Access
- 8 September 2024
- journal article
- research article
- Published by Wiley in Orthodontics & Craniofacial Research
- Vol. 28 (1) , 104-115
Abstract
Objective: The aim of this randomized controlled trial (RCT) was to evaluate the spontaneous distorotation of upper first permanent molars and the transverse dentoalveolar changes on digital casts in growing patients following maxillary expansion treatment using either the Leaf Expander® or the rapid maxillary expander (RME), both anchored to the deciduous second molar.Trial Design and Setting: This study was a two‐arm, parallel‐assignment, RCT with a dual‐centre design conducted at two teaching hospitals in Italy.Participants: Inclusion criteria included maxillary transverse deficiency, prepubertal development stage (cervical vertebra maturation stage [CVMS] 1–2) and early mixed dentition with fully erupted upper first permanent molars. Exclusion criteria were systemic diseases or syndromes, CVMS 3–6, agenesis of upper second premolars, unavailability of the second deciduous molar for anchorage and Class III malocclusion.Randomization: Patients were randomly assigned to the Leaf Expander® or RME group using a computer‐generated randomization list created by a central randomization centre. Randomization was conducted immediately before the start of treatment.Intervention: The intervention involved treatment with either the Leaf Expander® or the RME. Both devices were anchored to the second deciduous molars. Following randomization, patients were further categorized based on the presence of no crossbite, unilateral crossbite or bilateral crossbite.Main Outcome Measure: The primary outcome measure was the distorotation of the upper first molar (U6). Secondary outcomes included measurements of interdental linear dimensions, specifically upper inter‐canine width (53–63), upper inter‐molar width (MV16–MV26) and upper inter‐deciduous second molar width (55–65).Blinding: The examiner analysing the digital casts was blinded to the treatment groups to prevent detection bias and ensure objective assessment. However, due to the nature of the intervention, blinding was not feasible for the patients and clinicians involved in administering the treatment.Results: A total of 150 patients were enrolled and randomly assigned to two groups: 75 to the Leaf Expander® group and 75 to the RME group. Recruitment started in November 2021 and was completed in November 2022. At the time of analysis, the trial was complete with no ongoing follow‐ups. ANOVA tests revealed no significant differences between the three subgroups (no‐cross, unilateral‐cross and bilateral‐cross) within both the Leaf Expander® and RME groups at T0. The Leaf Expander® demonstrated significantly greater distorotation in the unilateral crossbite subgroup compared to the RME (p = .014). In terms of total molar distorotation, the Leaf Expander® appliance showed a significantly greater effect (12.66°) compared with conventional RME (7.83°). Linear regression analysis demonstrated a significant correlation between the extent of expansion and the degree of molar rotation.Conclusions: Maxillary expansion resulted in significant spontaneous molar distorotation when the appliance was bonded to the second deciduous molars. The Leaf Expander® exhibited significantly greater molar distorotation compared with conventional RME. The degree of molar distorotation was correlated with the extent of expansion obtained on the second deciduous molar.Trial Registration: The trial was registered at ClinicalTrials.gov (ID: NCT05135962).Keywords
This publication has 37 references indexed in Scilit:
- Comparison of the skeletal, dentoalveolar, and periodontal changes after Ni–Ti leaf spring expander and rapid maxillary expansion: a three-dimensional CBCT based evaluationClinical Oral Investigations, 2023
- Comparison between two screws for maxillary expansion: a multicenter randomized controlled trial on patient’s reported outcome measuresEuropean Journal of Orthodontics, 2020
- Factors related to maxillary expander loss due to anchoring deciduous molars exfoliation during treatment in the mixed dentition phaseEuropean Journal of Orthodontics, 2020
- Skeletal and dentoalveolar effects using tooth-borne and tooth-bone-borne RME appliances: a randomized controlled trial with 1-year follow-upEuropean Journal of Orthodontics, 2020
- Cephalometric and dental arch changes to Haas-type rapid maxillary expander anchored to deciduous vs permanent molars: a multicenter, randomized controlled trialJournal of Orofacial Orthopedics / Fortschritte der Kieferorthopädie, 2017
- Three-dimensional assessment of buccal alveolar bone after rapid and slow maxillary expansion: A clinical trial studyAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2013
- Skeletal and dental response to rapid maxillary expansion with 2- versus 4-band appliancesAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2005
- Role of posterior transverse interarch discrepancy in Class II, Division 1 malocclusion during the mixed dentition phaseAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1996
- Rapid maxillary expansion in the deciduous and mixed dentition evaluated through posteroanterior cephalometric analysisAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1995
- The effect of early interceptive treatment in children with posterior cross-biteEuropean Journal of Orthodontics, 1984