Design and Initial Evaluation of a Low-Cost Microprocessor-Controlled Above-Knee Prosthesis: A Case Report of 2 Patients
Open Access
- 10 February 2022
- journal article
- research article
- Published by MDPI AG in Prosthesis
- Vol. 4 (1) , 60-72
Abstract
For prosthesis users, knee units can range from simple devices costing $2000 up to $45,000 for high-end, microprocessor-controlled systems. These higher-end electronic knees provide significant advantages in stability, gait, and metabolic rate compared to their passive or mechanical counterparts. However, the high cost of such systems makes them inaccessible to most amputees. In this study, it was hypothesized that a microprocessor knee could be manufactured for less than $1000, with comparable stability and user experience to a high-end industry standard device. A prototype (E-Knee) was designed with a specific emphasis on stance stability, and was tested during patient gait trials. The gait trials used a repeated measures design to compare three knee devices (a simple passive knee, the prototype E-Knee, and a high-end knee). Ground reaction forces and a functionality questionnaire were used to compare devices. A microprocessor locking test was used to evaluate the prototype’s ability to prevent falls. Building on the LIMBS M3, a passive four-bar polycentric device, the E-Knee added sensing, computing, and controlling capabilities for a material cost of $507. Initial data from a two-subject trial served as proof-of-concept to validate the prototype and found that it improved gait by providing more stability than the M3 and had more gait-pattern similarities to the Ottobock C-Leg than to the M3. Patients reported no perceived differences in stability between the E-Knee and the C-Leg. Patient trials supported that the E-Knee prototype behaved more naturally than the low-end M3 device and had similar ground reaction forces to the C-Leg.Keywords
This publication has 26 references indexed in Scilit:
- Measures and procedures utilized to determine the added value of microprocessor-controlled prosthetic knee joints: a systematic reviewBMC Musculoskeletal Disorders, 2013
- Review of secondary physical conditions associated with lower-limb amputation and long-term prosthesis useJournal of Rehabilitation Research and Development, 2008
- Energy Expenditure and Activity of Transfemoral Amputees Using Mechanical and Microprocessor-Controlled Prosthetic KneesArchives of Physical Medicine and Rehabilitation, 2008
- Let Them Walk! Current Prosthesis Options for Leg and Foot AmputeesJournal of the American College of Surgeons, 2008
- Design and Control of a Powered Transfemoral ProsthesisThe International Journal of Robotics Research, 2008
- User‐adaptive control of a magnetorheological prosthetic kneeIndustrial Robot: the international journal of robotics research and application, 2003
- Limb Amputation and Limb DeficiencySouthern Medical Journal, 2002
- Time and frequency domain analysis of ground reaction forces during walking: an investigation of variability and symmetryGait & Posture, 1997
- The Influence of Four-Bar Linkage Knees on Prosthetic Swing-Phase Floor ClearanceJPO Journal of Prosthetics and Orthotics, 1996
- Normative data of knee joint motion and ground reaction forces in adult level walkingJournal of Biomechanics, 1983