Effect of cooling and lubrication conditions on cutting performance and surface integrity of Inconel 718 superalloy in end face milling
Authors:
Open Access
- 15 March 2023
- journal article
- research article
- Published by SAGE Publications in Advances in Mechanical Engineering
- Vol. 15 (3)
Abstract
Inconel 718 nickel-based superalloy has superior thermal and mechanical properties. Nevertheless, it is a hard-to-machine material, and the heat generated by processing is excessive. Reasonable cooling and lubrication (CL) methods have essential effects on its cutting performance and surface integrity. In this study, Dry cutting (DC), flood cutting (FC), cryogenic cutting (CC), and cryogenic minimum quantity lubrication cutting (CMQLC), are used to cutting Inconel 718 under the same parameters. Cutting forces, temperature, tool wear, chip, Ra, microstructure, and residual stress (RS) are measured. It is concluded that the combination of CL is beneficial for processing. The average temperature obtained by CMQLC is 55.47% lower than that of DC. And the workpiece obtained by CMQLC is measured compared with FC, the area of tool chipping is reduced by 25%, and the surface Ra is decreased by 32.05%, the lowest among the four methods. As for RS, although TRS increased by 7.9%, the MCRS and influence depth of the subsurface increased by 3.9% and 10.2% respectively. Furthermore, the machining condition with a high mechanical thermal ratio can obtain a more favorable RS state. Generally speaking, the CMQLC shows the advantages of mild environmental pollution, preferred cutting performance, and superior workpiece surface integrity.Keywords
Funding Information
- Shanghai Sailing Program (No.17YF1403100)
- Important National Science and Technology Specific Projects (No.2018ZX04040001)
This publication has 35 references indexed in Scilit:
- A study on droplets sizes, their distribution and heat exchange for minimum quantity cooling lubrication (MQCL)International Journal of Machine Tools and Manufacture, 2016
- Assessment of spray quality from an external mix nozzle and its impact on SQL grinding performanceInternational Journal of Machine Tools and Manufacture, 2015
- Residual stress influences on structural reliabilityEngineering Failure Analysis, 2011
- Study of cutting deformation in machining nickel-based alloy Inconel 718International Journal of Machine Tools and Manufacture, 2011
- Surface integrity in cryogenic machining of nickel based alloy—Inconel 718Journal of Materials Processing Technology, 2011
- Effects of Tool Wear on Subsurface Deformation of Nickel-based SuperalloyProcedia Engineering, 2011
- Cooling techniques for improved productivity in turningInternational Journal of Machine Tools and Manufacture, 2009
- Effect of machining parameters and cutting edge geometry on surface integrity of high-speed turned Inconel 718International Journal of Machine Tools and Manufacture, 2008
- Analysis of surface integrity for minimum quantity lubricant—MQL in grindingInternational Journal of Machine Tools and Manufacture, 2007
- Residual stress and surface roughness when facing age hardened Inconel 718 with CBN and ceramic cutting toolsInternational Journal of Machine Tools and Manufacture, 2004