Dickson charge pump circuit design with parasitic resistance in power lines
Author:
- 1 May 2009
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1763-1766
Abstract
Parasitic resistance in power and ground lines is considered for Dickson charge pump circuit designs, and its equivalent model is modified for low voltage IC designs. When the optimization is done for maximized output current or for minimized rise time, it is not necessary to increase the number of stages, but it is necessary to increase the pumping capacitors. The impact of the parasitic resistance in addition to the parasitic capacitance on charge pump circuit performances is discussed. The analytical results are compared with the SPICE simulation and the model has a sufficient accuracy within a typical error of 10%.Keywords
This publication has 8 references indexed in Scilit:
- Charge-pump circuits: power-consumption optimizationIEEE Transactions on Circuits and Systems I: Regular Papers, 2002
- An on-chip high-voltage generator circuit for EEPROMs with a power supply voltage below 2 V2002
- Optimization of word-line booster circuits for low-voltage flash memoriesIEEE Journal of Solid-State Circuits, 1999
- MOS charge pumps for low-voltage operationIEEE Journal of Solid-State Circuits, 1998
- A dynamic analysis of the Dickson charge pump circuitIEEE Journal of Solid-State Circuits, 1997
- Double and triple charge pump for power IC: dynamic models which take parasitic effects into accountIEEE Transactions on Circuits and Systems I: Regular Papers, 1993
- Analysis and modeling of on-chip high-voltage generator circuits for use in EEPROM circuitsIEEE Journal of Solid-State Circuits, 1989
- On-chip high-voltage generation in MNOS integrated circuits using an improved voltage multiplier techniqueIEEE Journal of Solid-State Circuits, 1976