Effect of Interlayer‐Compressed Argon Gas Active Cooling on Microstructure and Properties of Ti–6Al–4V Fabricated by WAAM
Authors:
- 11 August 2023
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 25 (20)
Abstract
Wire arc additive manufacturing (WAAM) has been widely used due to its advantages of low cost and high efficiency. However, one of the unsolved problems in WAAM is the heat accumulation. In this study, the compressed argon‐based interlayer active cooling (AC) process is employed to reduce heat accumulation, and the influence mechanism on microstructure and mechanical properties of Ti–6Al–4V samples are revealed. It is shown in the results that the introduction of interlayer AC leads to the interlayer temperature decreases from 468 to 53 °C, and the widths of prior‐β grains and αGB are refined. The increase of cooling rate (380–604 °C s−1) results in the transformation of large‐sized colonies into finer basket weave structure, accompanied by the production of martensite α’. The finer basket weave structure increases the strength of the samples, while the narrower αGB and the high‐angle grain boundaries increase the resistance of crack propagation. The high dislocation density caused by the faster cooling rate increases the plastic deformation to a certain extent. As a result, the interlayer AC improves the strength and plasticity of the samples simultaneously, the samples change from brittle and ductile‐mixed fracture to ductile fracture mode.Keywords
Funding Information
- Key Technologies Research and Development Program (2022YFB4602201)
- National Natural Science Foundation of China (52005351)
- China Postdoctoral Science Foundation (2022M722993)
This publication has 36 references indexed in Scilit:
- Robotic Nd:YAG Fiber Laser Welding of Ti-6Al-4V AlloyMetals, 2017
- Thermal analysis for single-pass multi-layer GMAW based additive manufacturing using infrared thermographyJournal of Materials Processing Technology, 2017
- The Influence of Gas Cooling in Context of Wire Arc Additive Manufacturing—A Novel Strategy of Affecting Grain Structure and Size2017
- Formation and control of martensite in Ti-6Al-4V alloy produced by selective laser meltingMaterials & Design, 2016
- Influence of microstructure on mechanical properties of laser metal wire-deposited Ti-6Al-4VMaterials Science and Engineering: A, 2016
- Electron beam melted Ti–6Al–4V: Microstructure, texture and mechanical behavior of the as-built and heat-treated materialMaterials Science and Engineering: A, 2016
- Graded microstructure and mechanical properties of additive manufactured Ti–6Al–4V via electron beam meltingActa Materialia, 2015
- Effect of inter-layer dwell time on distortion and residual stress in additive manufacturing of titanium and nickel alloysJournal of Materials Processing Technology, 2015
- Microstructure and Mechanical Properties of Wire and Arc Additive Manufactured Ti-6Al-4VMetallurgical and Materials Transactions A, 2012
- Additive manufacturing of Ti–6Al–4V components by shaped metal deposition: Microstructure and mechanical propertiesMaterials & Design (1980-2015), 2010