A universal‐input high‐power‐factor power supply without electrolytic capacitor for multiple lighting LED lamps
- 13 November 2011
- journal article
- research article
- Published by Wiley in International Journal of Circuit Theory and Applications
- Vol. 41 (5) , 514-534
Abstract
SUMMARY: The AC–DC power supply for LED lighting application requires a long lifetime while maintaining high‐efficiency, high power factor and low cost. However, a typical design uses electrolytic capacitor as storage capacitor, which is not only bulky but also with short life span, thus hampering performance improvement of the entire LED lighting system. In this article, a SEPIC‐derived power factor correction topology is proposed as the first stage for driving multiple lighting LED lamps. Along with a relatively large voltage ripple allowable in a two‐stage design, the proposal of LED lamp driver is able to eliminate the electrolytic capacitor while maintaining high power factor and high efficiency. To further increase the efficiency of LED driver, we introduced and used the twin‐bus buck converter as the second‐stage current regulator with Pulse Width Modulation (PWM) dimming function. The basic operating principle and the deign consideration are discussed in detail. A 50‐W prototype has been built and tested to verify the proposal. Copyright © 2011 John Wiley & Sons, Ltd.Keywords
This publication has 27 references indexed in Scilit:
- A novel single‐stage AC–DC converter with quasi‐resonant zero‐voltage‐switching for high power factor and high efficient applicationsInternational Journal of Circuit Theory and Applications, 2011
- Robust current control for boost PFC converters from a sliding mode viewpointInternational Journal of Circuit Theory and Applications, 2011
- Current‐fed isolated PFC pre‐regulator for multiple LED lamps with extended lifetimeInternational Journal of Circuit Theory and Applications, 2011
- A single‐stage LED lamp driver with low DC bus voltage for general lighting applicationsInternational Journal of Circuit Theory and Applications, 2010
- A simple PWM method for improving lamp current crest factor of valley‐filled electronic ballastInternational Journal of Circuit Theory and Applications, 2008
- Design considerations of an SEPIC PFC converter for driving multiple lighting LED lampsInternational Journal of Circuit Theory and Applications, 2008
- An improved single‐stage Flyback PFC converter for high‐luminance lighting LED lampsInternational Journal of Circuit Theory and Applications, 2007
- Statics and dynamics of fluorescent lamps operating at high frequency: modeling and simulationIEEE Transactions on Industry Applications, 2002
- A topology survey of single-stage power factor corrector with a boost type input-current-shaperIEEE Transactions on Power Electronics, 2001
- Electrodeless lamps for lighting: a reviewIEE Proceedings A Science, Measurement and Technology, 1993