Photoelectrochemical response studies of W deposited TiO2nanotubes via thermal evaporation technique
Open Access
- 4 July 2012
- journal article
- research article
- Published by Taylor & Francis in Journal of Experimental Nanoscience
- Vol. 9 (7) , 728-738
Abstract
Titania (TiO2) nanotube arrays were successfully formed by anodising titanium (Ti) foil in a standard two-electrode bath in 1 M of glycerol (HOCH2CH(OH)CH2OH) containing 0.5 wt% ammonium fluoride (NH4F). It was observed that such anodisation condition resulted in self-organised of TiO2 nanotubes with the average pore sizes of approximately 90 nm and the length was approximately 1 µm. In this study, various thicknesses of tungsten (W) were deposited on TiO2 nanotubes via thermal evaporation technique to investigate the photoelectrochemical (PEC) response and hydrogen generation rate. The improvement in PEC response was found by using a photoanode of 2.5 nm W deposited TiO2 nanotubes as compared to the pure TiO2 nanotubes. It was believed that a shallow trap was provided for charge carrier to inhibit the recombination and eventually extend the lifetime of charge carrier. In contrast, the higher deposition of W on TiO2 nanotubes resulted in lower PEC response because it acts as charge carrier recombination center. The experiment results show that the maximum photocurrent density of 0.9 mA/cm2 and maximum hydrogen production rate of 12 µL/cm2/min was achieved using 2.5 nm W deposited TiO2 nanotubes.Keywords
This publication has 40 references indexed in Scilit:
- Photoelectrochemical and photocatalytic activity of tungsten doped TiO2 nanotube layers in the near visible regionElectrochimica Acta, 2011
- Effect of Annealing Temperature on the Hydrogen Production of TiO2 Nanotube Arrays in a Two-Compartment Photoelectrochemical CellThe Journal of Physical Chemistry C, 2011
- Extremely Fast Growth Rate of TiO2 Nanotube Arrays in Electrochemical Bath Containing H2O2Journal of the Electrochemical Society, 2011
- Fabrication and characterization of multi-metal co-doped titania films for a water-splitting reactionDalton Transactions, 2010
- Decoration of TiO2 nanotube layers with WO3 nanocrystals for high-electrochromic activityElectrochemistry Communications, 2009
- Comparison of photoelectrochemical properties of TiO2-nanotube-array photoanode prepared by anodization in different electrolyteEnvironmental Chemistry Letters, 2008
- Synthesis and application of highly ordered arrays of TiO2 nanotubesJournal of Materials Chemistry, 2007
- WO3–TiO2 monolithic catalysts for high temperature SCR of NO by NH3: Influence of preparation method on structural and physico-chemical properties, activity and durabilityApplied Catalysis B: Environment and Energy, 2007
- Nano-Ag particles doped TiO2 for efficient photodegradation of Direct azo dyesJournal of Molecular Catalysis A: Chemical, 2006
- Influence of metallic silver and of platinum-silver bimetallic deposits on the photocatalytic activity of titania (anatase and rutile) in organic and aqueous mediaJournal of Photochemistry and Photobiology A: Chemistry, 1998