Vascular 3D Printing with a Novel Biological Tissue Mimicking Resin for Patient-Specific Procedure Simulations in Interventional Radiology: a Feasibility Study
Open Access
- 7 January 2022
- journal article
- research article
- Published by Springer Nature in Journal of Digital Imaging
- Vol. 35 (1) , 9-20
Abstract
Three-dimensional (3D) printing of vascular structures is of special interest for procedure simulations in Interventional Radiology, but remains due to the complexity of the vascular system and the lack of biological tissue mimicking 3D printing materials a technical challenge. In this study, the technical feasibility, accuracy, and usability of a recently introduced silicone-like resin were evaluated for endovascular procedure simulations and technically compared to a commonly used standard clear resin. Fifty-four vascular models based on twenty-seven consecutive embolization cases were fabricated from preinterventional CT scans and each model was checked for printing success and accuracy by CT-scanning and digital comparison to its original CT data. Median deltas (Δ) of luminal diameters were 0.35 mm for clear and 0.32 mm for flexible resin (216 measurements in total) with no significant differences (p > 0.05). Printing success was 85.2% for standard clear and 81.5% for the novel flexible resin. In conclusion, vascular 3D printing with silicone-like flexible resin was technically feasible and highly accurate. This is the first and largest consecutive case series of 3D-printed embolizations with a novel biological tissue mimicking material and is a promising next step in patient-specific procedure simulations in Interventional Radiology.Keywords
Funding Information
- Paracelsus Medical University
This publication has 30 references indexed in Scilit:
- 3D-printing techniques in a medical setting: a systematic literature reviewBioMedical Engineering OnLine, 2016
- Three-Dimensional Printing: An Enabling Technology for IRJournal of Vascular and Interventional Radiology, 2016
- Three-Dimensional Printing: Basic Principles and Applications in Medicine and RadiologyKorean Journal of Radiology, 2016
- Medical 3D Printing for the RadiologistRadioGraphics, 2015
- Using 3D printed models for planning and guidance during endovascular intervention: a technical advanceDiagnostic and Interventional Radiology, 2015
- Continuous liquid interface production of 3D objectsScience, 2015
- Use of a 3D Printed Hollow Aortic Model to Assist EVAR Planning in a Case With Complex Neck Anatomy: Potential of 3D Printing to Improve Patient OutcomeJournal of Endovascular Therapy, 2014
- Accuracy of treatment planning based on stereolithography in computer assisted surgerya)Medical Physics, 2006
- Fabrication of a wax ear by rapid-process modeling using stereolithography.1999
- Surgical Planning Using Three-Dimensional Imaging And Computer ModelingOtolaryngologic Clinics of North America, 1994