Numerical Study on Seismic Behavior of Flexural Frames with Semi-Rigid Welded Steel Connections Considering Static and Reciprocating Loads: A Performance-Based Earthquake Approach
Open Access
- 28 July 2022
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 12 (15) , 7617
Abstract
This paper aims to apply a performance-based earthquake engineering approach to assess the assurance of flexural frames whose members are jointed together by using new modified RBS connections, namely, semi-rigid welded steel connections, which obey a progressive failure mechanism. First, the structural members and connections are modeled and predesigned in ETABS software, and then, using OpenSees software, a series of nonlinear progressive failure analyses are performed on the built models extracted from ETABS. To this end, three types of multi-story structures with 3, 10, and 15 are modeled. The models are subjected to 15 earthquakes, such as Northridge (1994), Kobe (1995), Chichi (1999), Bam (2003), Tabas (1978), and so on. The connections are modeled by a series of rotational springs whose nonlinear behavior is estimated by a three-line curve that is established based on the modified Ibarra–Krawinkler deterioration model. Finally, obtaining the maximum ground acceleration versus the maximum relative drift of the floors, the fragility curves of the structures for a collapse level (CP) are determined, through which the seismic performances of the models are evaluated. The results show that by reducing the number of structural floors, the ductility of structures was reduced, and by increasing the ductility of structures, higher drifts in structures were achieved at the same seismic level. The average amount of ductility reduction coefficient in structures with RBS was 1.06 times those without RBS, which indicates that the energy dissipation capacity in structures without RBS connection is higher than in those with RBS. Local analysis of connections shows a 9% increase in the plastic rotation capacity if RBS connections are used. The ductility of all frames with RBS connection increased slightly compared to frames without RBS.Keywords
This publication has 17 references indexed in Scilit:
- Effectiveness of two conventional methods for seismic retrofit of steel and RC moment resisting frames based on damage control criteriaEarthquake Engineering and Engineering Vibration, 2017
- Accuracy of three-dimensional seismic ground response analysis in time domain using nonlinear numerical simulationsEarthquake Engineering and Engineering Vibration, 2017
- Improving the first-order structural reliability estimation by Monte Carlo simulationProceedings of the Institution of Civil Engineers - Structures and Buildings, 2017
- Probabilistic seismic loss estimation via endurance time methodEarthquake Engineering and Engineering Vibration, 2017
- Equating incremental dynamic analysis with static nonlinear analysis at near-field excitationEarthquake Engineering and Engineering Vibration, 2015
- Seismic behaviour of semi-rigid steel framesJournal of Constructional Steel Research, 1994
- Local stresses at the intersection of cross-beam flange with box-girder webThin-Walled Structures, 1993
- Nonlinear analysis of three-dimensional steel frames with semi-rigid connectionsComputers & Structures, 1991
- Theoretical modeling of semirigid connections behaviorJournal of Constructional Steel Research, 1991
- Semirigid Steel Beam‐to‐Column Connections: Data Base and ModelingJournal of Structural Engineering, 1989