Intensification of heat transfer during pool boiling of nitrogen on surfaces with capillary-porous coatings produced by 3D-printing
Authors:
- D V KuznetsovDKD V Kuznetsov
- A N PavlenkoAPA N Pavlenko
Open Access
- 1 October 2021
- conference paper
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 2039 (1)
Abstract
The study of heat transfer, critical heat fluxes (CHF) and evaporation dynamics at pool boiling of nitrogen at atmospheric and low pressures in a stationary heat generation regimes was performed. The two flat cooper heaters with porous coatings of various structural parameters obtained by additive 3D-printing as well as smooth one were used as working surfaces. According to obtained results such coatings significantly effect on pool boiling increasing up to six times the heat transfer coefficients (HTC) in comparison with uncoated sample. For all investigated heaters and pressures, visualization of boiling was performed using a video camera from which data on the bubble departure diameters and estimates of the active nucleation site density were obtained.Keywords
This publication has 8 references indexed in Scilit:
- Experimental Study on Heat Transfer and Critical Heat Flux during Pool Boiling of Nitrogen on 3D Printed Structured Copper Capillary-Porous CoatingsJournal of Engineering Thermophysics, 2021
- Pool boiling performance of 3D-printed reentrant microchannels structuresInternational Journal of Heat and Mass Transfer, 2020
- Development of a Technology for Creating Structured Capillary-Porous Coatings by Means of 3D Printing for Intensification of Heat Transfer during BoilingOptoelectronics, Instrumentation and Data Processing, 2019
- Performance of pool boiling with 3D grid structure manufactured by selective laser melting techniqueInternational Journal of Heat and Mass Transfer, 2019
- Saturated pool boiling enhancement using porous lattice structures produced by Selective Laser MeltingInternational Journal of Heat and Mass Transfer, 2018
- Boiling heat transfer on surfaces with 3D-printing microstructuresExperimental Thermal and Fluid Science, 2018
- Saturated pool boiling of FC-72 from enhanced surfaces produced by Selective Laser MeltingInternational Journal of Heat and Mass Transfer, 2016
- Selective laser melting of AlSi10Mg alloy: Process optimisation and mechanical properties developmentMaterials & Design (1980-2015), 2015