Design and Performance of Slurry Erosion Tester
- 1 April 2010
- journal article
- Published by ASME International in Journal of Tribology
- Vol. 132 (2) , 021601
Abstract
A slurry whirling arm erosion test ring was constructed and a series of erosion tests and post-erosion analysis were carried out using a paint erosion indication technique. The pattern of the paint removal presented a highly visual and accelerated map for the erosion process and its behavior. Also, the erosion rate of paint removal was investigated under a number of erosion variables. It was observed that the rebounding of the erodent particles from the sample surface play an important role in developing erosion for this tester. The erosion pattern showed that the effect of the rebound particles depends on the impact velocity and impingement angle. It was also observed that the erosion behavior of paint as a function of impingement angle, impact velocity, and erosion time was similar to that reported in literature for engineering materials. The slurry whirling arm erosion tester seems to be promising for simulating the slurry process in real cases.Keywords
This publication has 26 references indexed in Scilit:
- Investigations of sand–water induced erosive wear of AISI 304L stainless steel pipes by pilot-scale and laboratory-scale testingWear, 2003
- Erosion of ceramic materials by a sand/water slurry jetWear, 1999
- Design and performance of a high velocity air–sand jet impingement erosion facilityWear, 1998
- Some thoughts on the effect of elastic rebounds on the boundaries of the aqueous erosion-corrosion mapWear, 1998
- Slurry wear properties of pump lining materialsWear, 1997
- Erosion of polymer-particle composite coatings by liquid water jetsWear, 1997
- The abrasive and erosive wear of polymeric paint filmsWear, 1997
- Microstructural influence in slurry erosion of ceramicsWear, 1995
- Design of a slurry erosion test rigWear, 1990
- A New Flow-Through Slurry Erosion Wear Test1987