Adaptation, Marginal, and Occlusal Quality of Monolithic Zirconia Crowns: Effect of the CAD / CAM Milling Protocol
Open Access
- 9 May 2026
- journal article
- Published by Wiley in Journal of Esthetic and Restorative Dentistry
- Vol. 38 (9) , 1840-1847
Abstract
Objectives: Variables related to CAD/CAM processing can affect the final quality of all‐ceramic crowns. This study aims to evaluate the effect of the milling protocol on the adaptation, marginal and occlusal quality of monolithic zirconia crowns. Materials and Methods: Thirty‐nine monolithic zirconia crowns were produced using three CAD/CAM milling protocols ( n = 13): slow (S), normal (N), and fast (F). Adaptation (gap thickness) was evaluated using the replica technique, while marginal quality was assessed according to a severity scale. Occlusal quality was investigated qualitatively, using a stereomicroscope, and quantitatively, through an occlusal dimensional discrepancy analysis. Gap thickness and occlusal discrepancy data were analyzed with ANOVA and Tukey's test, and marginal quality with Kruskal–Wallis and Student–Newman–Keuls ( α = 0.05). Results: Gap thickness in the marginal, gingival‐axial angle and axial regions was similar among groups. In the axio‐occlusal angle and occlusal region, group N presented the smallest gap. For marginal quality, group F had higher scores in the severity scale than groups N and S for the mesial and buccal regions. Group F crowns showed less refined occlusal anatomy. Yet, when crowns produced with S and F protocols were compared with N, the total mean discrepancy was similar. Conclusion: The CAD/CAM milling protocol affected the adaptation, marginal, and occlusal quality of monolithic zirconia crowns.Keywords
Funding Information
- Fundação de Amparo à Pesquisa do Estado do Rio Grande do Sul (19/2551‐0000677‐2)
- Conselho Nacional de Desenvolvimento Científico e Tecnológico (302587/2017‐9)
This publication has 33 references indexed in Scilit:
- The Current State of Chairside Digital Dentistry and MaterialsDental Clinics of North America, 2019
- Impact of machining on the flexural fatigue strength of glass and polycrystalline CAD/CAM ceramicsDental Materials, 2017
- Monolithic zirconia dental crowns. Internal fit, margin quality, fracture mode and load at fractureDental Materials, 2017
- Strength, toughness and aging stability of highly-translucent Y-TZP ceramics for dental restorationsDental Materials, 2016
- Report on fractures of trilayered all-ceramic fixed dental prosthesesCase Studies in Engineering Failure Analysis, 2016
- Influence of convergence angle of tooth preparation on the fracture resistance of Y-TZP-based all-ceramic restorationsDental Materials, 2013
- Evaluation of marginal and internal fit of ceramic crown copingsDental Materials, 2013
- Effects of cement thickness and bonding on the failure loads of CAD/CAM ceramic crowns: Multi-physics FEA modeling and monotonic testingDental Materials, 2012
- Adaptation of all-ceramic fixed partial denturesDental Materials, 2011
- Microstructural and crystallographic surface changes after grinding zirconia‐based dental ceramicsJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2005