Heat generated by cutting ice in deep ice-core drilling
Authors:
- Nobuhiko AzumaNANobuhiko Azuma
- Hideaki MotoyamaHMHideaki Motoyama
Open Access
- 1 January 2007
- journal article
- Published by International Glaciological Society in Annals of Glaciology
- Vol. 47, 61-67
Abstract
In order to understand and solve the ‘warm-ice problem’ in deep ice-core drilling, we applied the metal-cutting theory to ice and estimated the heat generated during ice coring taking into account the mechanical and thermal properties of the ice and cutters. We found that (1) most of the heat in cutting is generated by shear deformation at the shear plane of ice, and the heat could increase the chip temperature by several degrees; (2) the rake angle of the cutter has more influence on the temperature increase in chips than the barrel rotation speed and penetration pitch; (3) if the cutter is made of a material with larger thermal conductivity, the temperature increase in the chips can be reduced; and (4) if the density of the liquid is less than the density of ice, the cutting chips sink to the bottom and the friction heat generated by the drill head and slush can raise the ambient temperature of the drill head by several degrees.Keywords
This publication has 7 references indexed in Scilit:
- Drilling comparison in ‘warm ice’ and drill design comparisonAnnals of Glaciology, 2007
- EPICA Dome C 2 drilling operations: performances, difficulties, resultsAnnals of Glaciology, 2007
- Power consumption of deep ice electromechanical drillsCold Regions Science and Technology, 2003
- The Confined Compressive Strength of Polycrystalline IceJournal of Glaciology, 1982
- Engineering Properties of Fresh-Water IceJournal of Glaciology, 1977
- The kinetic friction of iceProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1976
- Moving sources of heat and the temperature at sliding contactsJournal and proceedings of the Royal Society of New South Wales, 1943