Residual Stress Distribution and Fatigue Behavior of Combined Bolted–Welded Joints
Open Access
Abstract
Combined bolted–welded joints use both bolting and welding methods to connect several members, resulting in a versatile and robust solution for structural connections. However, very limited studies have focused on the residual stress distribution and fatigue behavior of these joints. In this paper, a total of eight specimens of double lap joints using bolts and fillet welds were fabricated and tested to measure the residual stress distribution. A finite element model was also developed for predicting the residual stress and residual deformation, and then it was validated against the test results. The effects of different welding parameters on the residual stress and residual deformation were evaluated, including the welding sequence (four different welding sequences) and welding process (welding speeds of 4 mm/s, 6 mm/s and 10 mm/s; welding powers of 5000 W, 6000 W and 7000 W; and post-weld heat treatments of no insulation, insulation at 200 °C and insulation at 300 °C). The fatigue behaviors of combined bolted–welded joints with and without residual stresses were compared in terms of the fatigue life of crack propagation. It was shown that the maximum residual stress was approximately 450 MPa, far exceeding the yield strength of steel plate of 335 MPa, while welding sequence 1 produced the smallest residual stresses. Due to the presence of welding residual stresses, the fatigue life of combined bolted–welded joints was reduced by nearly 40%, which indicated that the fatigue life of the joint would be overestimated without considering the residual stresses.Keywords
Funding Information
- National Natural Science Foundation of China (52478125, 2024GX-ZDCYL-03-09, 2021-11, 300102213207)
- Key Research and Development Program of Shaanxi Province (52478125, 2024GX-ZDCYL-03-09, 2021-11, 300102213207)
- verseas Students Science and Technology Activities Project Merit Funding in Shaanxi Province (52478125, 2024GX-ZDCYL-03-09, 2021-11, 300102213207)
- Fundamental Research Funds for Central Universities, CHD (52478125, 2024GX-ZDCYL-03-09, 2021-11, 300102213207)
This publication has 46 references indexed in Scilit:
- Effect of Post-Weld heat treatment on residual stress in deck-rib double-side welded joints and process optimizationEngineering Failure Analysis, 2024
- Through-thickness welding residual stress and its effect on stress intensity factors for semi-elliptical surface cracks in a butt-welded steel plateEngineering Fracture Mechanics, 2018
- Experimental and FE analysis of submerged arc weld induced residual stress and angular deformation of single and double sided fillet welded jointInternational Journal of Steel Structures, 2017
- Numerical Modeling and Mechanical Analysis of Combined Connection with Bolts and WeldsStrength of Materials, 2016
- 3D B-spline finite element nonlinear elasticity buckling analysis of rectangular FGM plates under non-uniform edge loads, using a micromechanical modelComposite Structures, 2014
- FEM study on the stress concentration factors of K-joints with welding residual stressApplied Ocean Research, 2013
- Residual stress effects on fatigue life of welded structures using LEFMEngineering Failure Analysis, 2009
- Prediction of welding distortion and residual stress in a thin plate butt-welded jointComputational Materials Science, 2008
- Numerical simulation of temperature field and residual stress in multi-pass welds in stainless steel pipe and comparison with experimental measurementsComputational Materials Science, 2006
- A new finite element model for welding heat sourcesMetallurgical Transactions B, 1984