In situ study on interactions between hydroxyl groups in kaolinite and re-adsorption water
Open Access
- 30 April 2020
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 10 (29) , 16949-16958
Abstract
The interactions between O–H groups in kaolinite and re-adsorption water is an important aspect that should be considered in the hydraulic fracturing method for the production of shale gas, because the external water adsorbed by kaolinite in shale would significantly affect the desorption of methane. In this study, the interactions were investigated via changing the amount of O–H groups and re-adsorption water in kaolinite by heating treatment and water re-adsorption. To overcome the overlap of IR vibration bands of the O–H functional groups in H2O and those in parent kaolinite, kaolinite samples with D2O re-adsorption were prepared by drying the H2O from raw kaolinite and soaking the dried kaolinite in D2O. The interactions between O–H groups in kaolinite and D2O molecules were investigated by in situ DRIFT and TG-MS. The results demonstrated that the vibration at 3670 ± 4 cm−1 in the DRIFT spectra could be due to the outer O–H groups of the octahedral sheet on the upper surface of the kaolinite microcrystal structure, rather than a type of inner-surface O–H group. All types of O–H groups, including the inner O–H groups in kaolinite, could be transformed into O–D groups after D2O re-adsorption at room temperature. The inner-surface O–H groups in kaolinite are the most preferred sites for D2O re-adsorption; thus, they would be the key factor for studying the effect of re-adsorption water on methane desorption. When the temperature increased from 100 °C to 300 °C, two layers of kaolinite slipped away from each other, resulting in the transformation of inner-surface O–H groups into outer O–H groups. Thus, the temperature range of 100 to 300 °C was suggested for the heat treatment of kaolinite to decrease the content of inner-surface O–H groups; thereby, the amount of re-adsorption water was reduced. However, to thoroughly remove the re-adsorption water, a temperature higher than 650 °C should be used.Keywords
Funding Information
- National Natural Science Foundation of China (21805202)
- National Natural Science Foundation of China (51574172)
- National Natural Science Foundation of China (U1710258)
- National Natural Science Foundation of China (51925402)
- Shanxi Province Science Foundation for Youths (201801D221359)
This publication has 48 references indexed in Scilit:
- The behaviour of water on the surface of kaolinite with an oscillating electric fieldRSC Advances, 2019
- Oscillating Electric Field Effects on Adsorption of the Methane–Water System on Kaolinite SurfaceEnergy & Fuels, 2018
- Pore characterization and clay bound water assessment in shale with a combination of NMR and low-pressure nitrogen gas adsorptionInternational Journal of Coal Geology, 2018
- Effect of water on methane adsorption on the kaolinite (0 0 1) surface based on molecular simulationsApplied Surface Science, 2018
- The impact of the volumetric swelling behavior on the water uptake of gas shaleJournal of Natural Gas Science and Engineering, 2018
- Adsorption Behavior of Methane on KaoliniteIndustrial & Engineering Chemistry Research, 2017
- Molecular simulation of methane adsorption in slit-like quartz poresRSC Advances, 2016
- Water imbibition of shale and its potential influence on shale gas recovery—a comparative study of marine and continental shale formationsJournal of Natural Gas Science and Engineering, 2016
- Adhesion of Oil to Kaolinite in WaterEnvironmental Science & Technology, 2010
- Infrared Study of the OH Groups in Expanded KaoliniteScience, 1964