Feasibility Study of the Flatness of a Plastic Injection Molded Pallet by a Newly Proposed Sequential Valve Gate System
Open Access
Abstract
The investigation of plastic pallet molding, assisted by a sequential valve gate system, has not yet been performed due to the limitations of the pallet scale. Furthermore, at present, the application of recycled plastics by chemical industries has become extremely popular around the world. This study aimed to determine pallet flatness experimentally and numerically using recycled polypropylene with a large-scale pallet. Short-shot testing on injection molding was performed to obtain short-shot samples for confirmation of the flow front during simulated filling. The real injected pallet profile, which was measured by an ATOS, was compared after confirmation to the numerical profile of the pallet. The pallet’s flatness was accurately compared to the real experimental and numerical results. By adjusting the temperature of the cooling channel within the cavity plate to 55 °C, the flatness of the pallet achieved by the newly proposed sequential valve gate-opening scheme was about 7 mm, which meets the height directional warpage standard determined by the pre-set sequential scheme. The numerical flatness is in line with existing flatness values for pallets. Furthermore, the proposed cooling temperature gives the highest yield in terms of pallet molding from the perspective of the stakeholders.Keywords
Funding Information
- Nan-Ya Plastics Inc. (I01109E021)
This publication has 28 references indexed in Scilit:
- Numerical Simulation and Experimental Investigation of the Viscoelastic Heating Mechanism in Ultrasonic Plasticizing of Amorphous Polymers for Micro Injection MoldingPolymers, 2016
- Simulation of Jetting in Injection Molding Using a Finite Volume MethodPolymers, 2016
- Warpage prediction of the injection-molded strip-like plastic partsChinese Journal of Chemical Engineering, 2016
- Warpage control of thin-walled injection molding using local mold temperaturesInternational Communications in Heat and Mass Transfer, 2015
- Experimental investigation of plastic injection molding: Assessment of the effects of cavity pressure and mold temperature on the quality of the final productsMaterials & Design (1980-2015), 2009
- Effect of Mold Temperature on Mechanical Properties of an Injection-Molded Part with MicrofeaturesJournal of Polymer Engineering, 2009
- Warpage and structural analysis of thin shell plastic in the plastic injection moldingMaterials & Design (1980-2015), 2009
- Three Models of the 3D Filling Simulation for Injection Molding: A Brief ReviewJournal of Reinforced Plastics and Composites, 2008
- Warpage prediction of optical mediaJournal of Polymer Science Part B: Polymer Physics, 2003
- Numerical simulation of mold filling in injection molding using a three‐dimensional finite volume approachInternational Journal for Numerical Methods in Fluids, 2001