Computational Analysis of Quality Reduction during Drying of Lumber due to Irrecoverable Deformation. I: Orthotropic Viscoelastic-Mechanosorptive-Plastic Material Model for the Transverse Plane of Wood
Authors:
- 1 September 2003
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Engineering Mechanics
- Vol. 129 (9) , 996-1005
Abstract
This paper presents the development of an orthotropic material model for the mechanical analysis of wood in the plane perpendicular to the growth direction. It is based on an earlier uniaxial development and experimental verification. The novel features are the biaxial extension and the description of partially irrecoverable creep deformation by enhancing a viscoelastic-mechanosorptive creep model by coupling it with orthotropic plasticity. The mathematical description of both the equations of state and the evolution laws are formulated on a thermodynamical basis. A semianalytical solution algorithm is derived for the obtained nonlinear system of differential equations. The model is applicable over a wide range of temperature as well as moisture content (20–120°C; nearly 0% moisture content to fiber saturation), which is achieved through application of the time-temperature-moisture superposition principle and the introduction of a moisture-change-temperature superposition principle. A set of material para...Keywords
This publication has 18 references indexed in Scilit:
- Computational Analysis of Quality Reduction during Drying of Lumber due to Irrecoverable Deformation. II: Algorithmic Aspects and Practical ApplicationJournal of Engineering Mechanics, 2003
- Some remarks on the compressed matrix representation of symmetric second-order and fourth-order tensorsComputer Methods in Applied Mechanics and Engineering, 2001
- Deformation properties of Finnish spruce and pine wood in tangential and radial directions in association to high temperature drying¶Part IV. ModellingEuropean Journal of Wood and Wood Products, 2000
- Deformation properties of Finnish spruce and pine wood in tangential and radial directions in association to high temperature drying. Part III. Experimental results under drying conditions (mechano-sorptive creep)European Journal of Wood and Wood Products, 2000
- Deformation properties of Finnish spruce and pine wood in tangential and radial directions in association to high temperature dryingEuropean Journal of Wood and Wood Products, 1999
- Deformation properties of finnish spruce and pine wood in tangential and radial directions in association to high temperature dryingEuropean Journal of Wood and Wood Products, 1998
- The drying stress and check development on high-temperature kiln seasoning of sapwoodPinus radiata boardsEuropean Journal of Wood and Wood Products, 1997
- The drying stress and check development on high-temperature kiln seasoning of sapwoodPinus radiata boardsEuropean Journal of Wood and Wood Products, 1997
- Linearity and non-linearity in mechano-sorptive creep of softwood in compression and bendingWood Science and Technology, 1989
- Requirements for a model that exhibits mechano-sorptive behaviourWood Science and Technology, 1976