Beamforming Applied to Ultrasound Analysis in Detection of Bearing Defects
Open Access
Abstract
The bearings of rotating machinery often fail, leading to unforeseen downtime of large machines in industrial plants. Therefore, condition monitoring can be a powerful tool to aid in the quick identification of these faults and make it possible to plan maintenance before the fault becomes too drastic, reducing downtime and cost. Predictive maintenance is often based on information gathered from accelerometers. However, these sensors are contact-based, making them less attractive for use in an industrial plant and more prone to breakage. In this paper, condition monitoring based on ultrasound is researched, where non-invasive sensors are used to record the noise originating from different defects of the Machinery Fault Simulator. The acoustic data are recorded using a sparse microphone array in a lab environment. The same array was used to record real spatial noise in a fully operational plant which was later added to the acoustic data containing the different defects with a variety of Signal To Noise ratios. In this paper, we compare the classification results of the noisy acoustic data of only one microphone to the beamformed acoustic data. We do this to investigate how beamforming could improve the classification process in an ultrasound condition-monitoring application in a real industrial plant.Keywords
This publication has 33 references indexed in Scilit:
- Analysing RMS and peak values of vibration signals for condition monitoring of wind turbine gearboxesRenewable Energy, 2016
- Motor Bearing Fault Detection Using Spectral Kurtosis-Based Feature Extraction Coupled With K-Nearest Neighbor Distance AnalysisIEEE Transactions on Industrial Electronics, 2015
- Rotor fault diagnosis for machinery fault simulator under varied loads2013
- Fault Diagnosis of Bearing Based on the Ultrasonic SignalAdvanced Materials Research, 2011
- A Comparison Study Between Acoustic Sensors for Bearing Fault Detection Under Different Speed and Load Using a Variety of Signal Processing TechniquesTribology Transactions, 2011
- CONDITION MONITORING FOR INDEXABLE CARBIDE END MILL USING ACCELERATION DATAMachining Science and Technology, 2010
- Sensitivity of Air-Coupled Ultrasound and Eddy Current Sensors to Bearing Fault DetectionTribology Transactions, 2008
- Condition Monitoring of Low Speed Bearings: A Comparative Study of the Ultrasound Technique Versus Vibration Measurements2008
- The spectral kurtosis: a useful tool for characterising non-stationary signalsMechanical Systems and Signal Processing, 2006
- A review of vibration and acoustic measurement methods for the detection of defects in rolling element bearingsTribology International, 1999