Flow Regime Identification in a Bubble Column Based on Both Statistical and Chaotic Parameters Applied to Computed Tomography Data
- 31 August 2006
- journal article
- research article
- Published by Wiley in Chemical Engineering & Technology
- Vol. 29 (9) , 1054-1060
Abstract
The Kolmogorov entropy (KE) algorithm was applied successfully to single source γ‐ray Computed Tomography (CT) data measured in a 0.162 m ID bubble column equipped with a perforated plate distributor (163 holes · ∅︁ 1.32 mm). Dried air was used as the gas phase and Therminol LT (ρL = 886 kg m–3, μL = 0.88 · 10–3 Pa s, σ = 17 · 10–3 N m–1) was used as a liquid phase. Three different pressures, P, of 0.1, 0.4, and 1.0 MPa were examined. At each pressure the superficial gas velocity, uG, was increased stepwise by steps of 0.01 m s–1 up to 0.2 m s–1. The average absolute deviation (AAD) was also used as a robust statistical criterion for regime transition. At all three pressures, based on the sudden changes in both the AAD and KE values, the boundaries of the following five regimes were identified: dispersed bubble regime, first and second transition regimes, coalesced bubble regime consisting of four regions (called 4‐region flow), and coalesced bubble regime consisting of three regions (called 3‐region flow). The existence of these regimes has already been documented. As the pressure increases, the transition velocity between the dispersed bubble and first transition regimes and the transition velocity between coalesced bubble (4‐region flow) and coalesced bubble (3‐region flow) regimes shift to higher uG values. On the other hand, at P = 0.4 MPa the second transition regime starts earlier. In addition, at P = 1 MPa the transition to coalesced bubble (4‐region flow) is delayed.Keywords
This publication has 30 references indexed in Scilit:
- Characterization of the hydrodynamic flow regime in bubble columns via computed tomographyFlow Measurement and Instrumentation, 2005
- Flow Regime Identification in a Slurry Bubble Column from Gas Holdup and Pressure Fluctuations AnalysisThe Canadian Journal of Chemical Engineering, 2004
- Identification of Flow Regimes in a Flat Gas‐liquid Bubble Column via Wavelet TransformThe Canadian Journal of Chemical Engineering, 2003
- Description of flow regime transitions in bubble columns via laser Doppler anemometry signals processingChemical Engineering Science, 2003
- A simple method for regime identification and flow characterisation in bubble columns and airlift reactorsChemical Engineering and Processing - Process Intensification, 2001
- Duality of the gas-liquid flow regimes in bubble column reactorsChemical Engineering Science, 1997
- Quantitative analysis and computation of two‐dimensional bubble columnsAIChE Journal, 1996
- Flow structure in a three‐dimensional bubble column and three‐phase fluidized bedAIChE Journal, 1994
- The use of fractal techniques for flow regime identificationInternational Journal of Multiphase Flow, 1991
- Flow pattern characterization in two phase flow by electrical conductance probeInternational Journal of Multiphase Flow, 1980