Fabrication of a cost effective thermal evaporation system for thin film deposition
Authors:
- 1 September 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 93, 703-706
Abstract
Motivation of this work is to deposit thin film by thermal evaporation technique that involves heating a solid material inside a highly vacuum chamber, at a temperature that produces vapor pressure yielding to an adhesive force enough for the film to be grown on the substrate. The system incorporates a vacuum chamber with a heater which raises the temperature to a sufficient level to deposit thin film on desired substrate. On the contrary, to maintain the system in an effective cost extent the instrumental set up is customized. Therefore, constituents of the system such as heating chamber, heater, vacuum-pump and steel substrate holder are designed with easily available equipment according to the pre-requirement without any kind of downfall in the quality of the thin film. Afterwards Zinc Oxide thin film is obtained by controlling the necessary parameters for thermal evaporation technique with this system followed by the measurement of optical characteristics and band gap energy of deposited thin film by Spectrophotometer.Keywords
This publication has 5 references indexed in Scilit:
- Influence of substrate temperature on structural and optical properties of ZnO thin films prepared by cost-effective chemical spray pyrolysis techniqueSuperlattices and Microstructures, 2016
- Zinc oxide thin film fabricated by thermal evaporation method for water splitting application2015
- Synthesis and characterization of ZnO thin films by thermal evaporationJournal of Physics and Chemistry of Solids, 2009
- Zinc oxide thin films prepared by thermal evaporation deposition and its photocatalytic activityApplied Catalysis B: Environment and Energy, 2006
- Micro-Raman and infrared properties of SnO2 nanobelts synthesized from Sn and SiO2 powdersJournal of Applied Physics, 2003