Effect of Light Emission Through an Optical Fiber Device on the Bond Strength of a Hollow Experimental Intraradicular Post
Open Access
- 1 January 2022
- journal article
- research article
- Vol. 24 (1) , 325-333
Abstract
Purpose: To evaluate the effect of irradiation with an optical-fiber device on the bond strength of hollow and partially opaque intraradicular posts. Materials and Methods: An optical-fiber accessory tip was attached to a light-curing unit to emit light through the central hollow of an experimental fiberglass post. The samples were divided into 4 groups (n = 80) according to the protocol (Variolink N [light cured] or Multilink N [dual-curing luting material]) and the light-curing mode (performed conventionally or with the optical fiber): GF: light-curing luting material; GFF: light-curing luting material and optical fiber; GD: dual-curing luting material; GDF: dual-curing luting material and optical fiber. The samples were tested immediately or after aging. Push-out bond strength, failure mode, degree of conversion (DC, assessed at the peak of 1750 cm-1), and stress distribution by finite element analysis were performed. Quantitative data were analyzed using 3-way ANOVA (luting material x light curing x depth) and 2-way ANOVA (aging x luting material), followed by Tukey's test. Results: Bond strength was significantly affected by the luting material protocol (p < 0.001), depth (p = 0.010), and light curing mode (p = 0.031). The GFF group revealed higher bond strength in the middle and apical portions. The most frequent failure modes were adhesive in the apical portion for the GFF and GDF groups. The DC was higher for GF and GFF groups. Conclusion: Using the optical-fiber device led to superior bond strength results when a dual-curing luting material was used.Keywords
This publication has 26 references indexed in Scilit:
- Effect of LED-LCU light irradiance distribution on mechanical properties of resin based materialsMaterials Science and Engineering: C, 2016
- Localised irradiance distribution found in dental light curing unitsJournal of Dentistry, 2014
- A brief history of LED photopolymerizationDental Materials, 2013
- Effect of Resin Cement System and Root Region on the Push-out Bond Strength of a Translucent Fiber PostOperative Dentistry, 2012
- Fiber post placement with core build-up materials or resin cements—An evaluation of different adhesive approachesActa Odontologica Scandinavica, 2011
- Is Adhesive Cementation of Endodontic Posts Necessary?Journal of Endodontics, 2008
- An evaluation of luting agent application technique effect on fibre post retentionJournal of Dentistry, 2008
- Laboratory assessment of the retentive potential of adhesive posts: A reviewJournal of Dentistry, 2007
- Mechanical characterization of resin cements used for luting fiber posts by nanoindentationDental Materials, 2007
- Influence of dentin bonding agents and polymerization modes on the bond strength between translucent fiber posts and three dentin regions within a post spaceThe Journal of Prosthetic Dentistry, 2006