Stress Corrosion Cracking of Sensitized Type 304 Stainless Steel in Hydrochloric Acid Solution—Predicting Time-to-Failure and Effect of Sensitizing Temperature
Authors:
- 1 October 2001
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 57 (10) , 853-862
Abstract
The stress corrosion cracking (SCC) of a commercial austenitic stainless steel, Type 304 (UNS S30400), has been investigated as a function of sensitizing temperature (800 K to 1,300 K) and test temperature (333 K to 373 K) in 0.82 kmol/m2 hydrochloric acid (HCl) solution using a constant load method. The three parameters were measured as a function of applied stress (σ), time-to-failure (tf), steady-state elongation rate (l˙ss), and transition time (tss, the time when the elongation starts to deviate from linearity before final failure). Curves for the sensitized specimens were divided into three regions that were dominated by either stress, SCC, or general corrosion. In the SCC-dominated region, the logarithm of l˙ss, which is obtained from the elongation vs time curve, is a linear function of the logarithm of tf, irrespective of σ and test temperature, although the slope depends upon sensitizing temperature. This result implies that l˙ss could be a useful parameter for the prediction of tf for sensitized as well as for solution-annealed specimens. Furthermore, the maximum applied stress in the SCC-dominated region, the value of tss/tf and the fracture mode (transgranular or intergranular), were found to depend upon sensitizing temperature. Results obtained are qualitatively discussed in terms of the interaction between the film formed at crack tips and grain boundary sliding (GBS), Cr carbides, and the grain boundary Cr depletion zone.Keywords
This publication has 8 references indexed in Scilit:
- Life prediction on SCC of solution annealed stainless steels under laboratory conditionsNuclear Engineering and Design, 1998
- The effect of anodic polarization on the ambient creep of brassCorrosion Science, 1994
- The effect of potential on stress corrosion cracking of type 316 and type 310 austenitic stainless steelsCorrosion Science, 1993
- Stress Corrosion Cracking of Type 430 Ferritic Stainless Steel in Chloride and Sulfate SolutionsCorrosion, 1992
- SCC Failure Prediction of Austenitic Stainless Steels in Acid SolutionsCorrosion, 1990
- Stress Corrosion Cracking of AISI 304 and AISI 316 Austenitic Stainless Steels in HCl and H2SO4 Solutions — Prediction of Time-to-Failure and Criterion for Assessment of SCC SusceptibilityCorrosion, 1989
- Sensitization of Austenitic Stainless Steels II. Commercial Purity AlloysCorrosion, 1983
- Film-rupture mechanism of stress corrosionJournal of Research of the National Bureau of Standards, 1952