Process Optimization and Microstructure Characterization of Ti6Al4V Manufactured by Selective Laser Melting
Authors:
Open Access
- 29 November 2017
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 269 (1) , 012026
Abstract
Process optimization and microstructure characterization of Ti6Al4V manufactured by selective laser melting (SLM) were investigated in this article. The relative density of sampled fabricated by SLM is influenced by the main process parameters, including laser power, scan speed and hatch distance. The volume energy density (VED) was defined to account for the combined effect of the main process parameters on the relative density. The results shown that the relative density changed with the change of VED and the optimized process interval is 55~60J/mm 3. Furthermore, compared with laser power, scan speed and hatch distance by taguchi method, it was found that the scan speed had the greatest effect on the relative density. Compared with the microstructure of the cross-section of the specimen at different scanning speeds, it was found that the microstructures at different speeds had similar characteristics, all of them were needle-like martensite distributed in the β matrix, but with the increase of scanning speed, the microstructure is finer and the lower scan speed leads to coarsening of the microstructure.Keywords
This publication has 14 references indexed in Scilit:
- Tribological behavior of Ti6Al4V cellular structures produced by Selective Laser MeltingJournal of the Mechanical Behavior of Biomedical Materials, 2017
- Porous Selective Laser Melted Ti and Ti6Al4V Materials for Medical Applications2017
- Advances in 3D Printing & Additive Manufacturing Technologies2017
- Performance of High Layer Thickness in Selective Laser Melting of Ti6Al4VMaterials, 2016
- A survey on mechanisms and critical parameters on solidification of selective laser melting during fabrication of Ti-6Al-4V prosthetic acetabular cupMaterials & Design, 2016
- Microstructure, defects and mechanical behavior of beta-type titanium porous structures manufactured by electron beam melting and selective laser meltingActa Materialia, 2016
- Analysis of defect generation in Ti–6Al–4V parts made using powder bed fusion additive manufacturing processesAdditive Manufacturing, 2014
- Parametric optimization of selective laser melting for forming Ti6Al4V samples by Taguchi methodOptics & Laser Technology, 2013
- Parametric analysis of the selective laser melting processApplied Surface Science, 2007
- Titanium and Titanium Alloys2003