All-solid-state batteries (ASSBs), which incorporate nonflammable solid electrolytes, are expected to be the next generation batteries due to their high safety. However, the practical application of ASSBs requires an improvement in battery performance. From the perspective of the charge transfer pathway, understanding the solid-to-solid contact between battery materials is crucial for enhancing battery performance. Especially, quantifying the change in solid-to-solid contact between active material (AM) and solid electrolyte (SE) depending on various AM shapes is necessary. In this study, the effect of AM shapes on the contact characteristics inside electrode layers was investigated using the discrete element method (DEM). Three-dimensional DEM code developed in our group was used [1] . DEM is a method for analyzing powder behavior by calculating the motion of solid particles based on Newton’s second law for their time evolution. Electrode structures filled with either spherical or plate-like AM particles and spherical SE particles were generated. AM particles were constructed as aggregates ( dp = 7 µm) composed of primary particles ( dp = 1 µm). SE particles were considered as single spherical particles ( dp = 1 µm). The volume ratio of AM to SE was set to 6:4. The electrodes were compressed at the specified pressure and then unloaded. The contact angle and stress between the AM and SE particles were calculated to analyze contact characteristics. The results showed that the contact characteristics differed depending on the particle shapes. In the case of spherical AM particles, the contact angle frequency indicated isotropy. Meanwhile, in the case of plate-like AM particles, the contact angle frequency was anisotropic because thickness direction had many contacts. For single crystals, the ionic diffusion coefficient is anisotropic [2] . Therefore, contact anisotropy has a significant effect on battery performance. The distribution of stress per particle was also evaluated. The stress distribution in the spherical AM condition was smaller than that in the plate-like AM condition. These results showed the importance of optimizing the packing structure depending on particle shape. In this study, contact characteristics and stress distribution in electrode layers with different AM particle shapes were evaluated by numerical simulation. The findings of this study are that contact characteristics and stress distribution vary with particle shape. These results emphasized that optimization of the packing structure is important for improving the battery performance of ASSBs. In the future, these studies will be expanded to investigate the effect of particle shape on battery performance. Acknowledgment This study was supported by JST-Mirai Program Grant Number JPMJMI24G1, Japan. References [1] M. So et al ., MethodsX , 9 , 101857 (2022). [2] X. Zhu et al ., J Materiomics , 8 , 649-655 (2022).