The effect of the rate of precursor production on the purity and aggregation morphology of nanoparticulate zinc oxide
- 1 January 2007
- journal article
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 17 (2) , 181-184
Abstract
The synthesis of zinc oxide through the decomposition of a solid oxalate precursor was investigated. It was found that the rate of preparation of the precursor had a quantitative effect on the morphology and extent of surface ligation of particles produced; contrary to our expectations, it was found that the slow combination of reagents led to a less pure product. It has been determined that this time dependence mimics the variation of reactant ratios. Zinc oxide particles were produced from a number of reactant ratios, and were characterised by TEM, XRD, FT-IR and DSC. It was found that the size of the crystallites produced was not affected, but that the nature of their surface ligation did rely upon these parameters.Keywords
This publication has 14 references indexed in Scilit:
- Microwave Synthesis of Supported Au and Pd Nanoparticle Catalysts for CO OxidationThe Journal of Physical Chemistry B, 2005
- Self-assembled arrays of ZnO nanoparticles and their application as varistor materialsElectronic supplementary information (ESI) available: XRD plots and FESEM images. See http://www.rsc.org/suppdata/jm/b4/b400927d/Journal of Materials Chemistry, 2004
- The effect of processing conditions on varistors prepared from nanocrystalline ZnOJournal of Materials Chemistry, 2003
- Synthesis of ZnO nanopowder via an aqueous acetate–citrate gelation methodMaterials Research Bulletin, 2002
- Room-Temperature Ultraviolet Nanowire NanolasersScience, 2001
- Recent advances in ZnO materials and devicesMaterials Science and Engineering: B, 2001
- Optimization of zinc oxide thin film for surface acoustic wave filters by radio frequency sputteringVacuum, 2000
- Physicochemical surface and catalytic properties of CuO–ZnO/Al2O3 systemApplied Catalysis A: General, 1999
- Zinc-oxide thin-film ammonia gas sensors with high sensitivity and excellent selectivityJournal of Applied Physics, 1986
- The detection and measurement of CO using ZnO single crystalsSensors and Actuators, 1984