Experimental Study and Model Predictive Control of a Lean-Burn Gasoline Engine Coupled With a Passive Selective Catalytic Reduction System
- 2 May 2019
- journal article
- research article
- Published by ASME International in Journal of Dynamic Systems, Measurement, and Control
- Vol. 141 (9)
Abstract
Lean-burn gasoline engines have demonstrated 10–20% engine efficiency gain over stoichiometric engines and are widely considered as a promising technology for meeting the 54.5 miles-per-gallon (mpg) corporate average fuel economy standard by 2025. Nevertheless, nitrogen oxides (NOx) emissions control for lean-burn gasoline for meeting the stringent Environmental Protection Agency tier 3 emission standards has been one of the main challenges toward the commercialization of highly efficient lean-burn gasoline engines in the United States. Passive selective catalytic reduction (SCR) systems, which consist of a three-way catalyst (TWC) and SCR, have demonstrated great potentials of effectively reducing NOx emissions for lean gasoline engines at low cost. However, passive SCR operation may cause significant fuel penalty since rich engine combustion is required for ammonia generation. The purpose of this study is to develop a model-predictive control (MPC) scheme for a lean-burn gasoline engine coupled with a passive SCR system to minimize the total equivalent fuel penalty associated with passive SCR operation while satisfying stringent NOx and ammonia (NH3) emissions requirements. Simulation results demonstrate that the MPC approach can reduce the fuel penalty by 43.9% in a simulated US06 cycle and 28.0% in a simulated urban dynamometer driving schedule (UDDS) cycle, respectively, compared to the baseline control, while achieving over 97% DeNOx efficiency and less than 15 ppm tailpipe ammonia slip. The proposed MPC controller can potentially enable highly efficient lean-burn gasoline engines while meeting the stringent Environmental Protection Agency tier 3 emission standards.Keywords
This publication has 23 references indexed in Scilit:
- Ammonia formation from nitric oxide over Pd-based catalysts in multicomponent feed gas compositionsCatalysis Communications, 2017
- Passive SCR for lean gasoline NOX control: Engine-based strategies to minimize fuel penalty associated with catalytic NH3 generationCatalysis Today, 2016
- Passive SCR: The Effect of H $_2$ 2 to NO Ratio on the Formation of NH $_3$ 3 Over Alumina Supported Platinum and Palladium CatalystsTopics in Catalysis, 2016
- Ammonia Generation and Utilization in a Passive SCR (TWC+SCR) System on Lean Gasoline EngineSAE International Journal of Engines, 2016
- Vehicular Emissions in ReviewSAE International Journal of Engines, 2016
- Review of Vehicular Emissions TrendsSAE International Journal of Engines, 2015
- Passive TWC+SCR Systems for Satisfying Tier 2, Bin 2 Emission Standards on Lean-Burn Gasoline EnginesSAE International Journal of Fuels and Lubricants, 2015
- Ammonia formation over supported platinum and palladium catalystsApplied Catalysis B: Environment and Energy, 2015
- Passive-ammonia selective catalytic reduction (SCR): Understanding NH3 formation over close-coupled three way catalysts (TWC)Catalysis Today, 2014
- Passive Ammonia SCR System for Lean-burn SIDI EnginesSAE International Journal of Fuels and Lubricants, 2010