Necking limit of substrate-supported metal layers under biaxial in-plane loading
Authors:
- Zheng JiaZJZheng Jia
- Teng LiTLTeng Li
- 1 December 2013
- journal article
- Published by Elsevier in International Journal of Plasticity
- Vol. 51, 65-79
Abstract
No abstract availableKeywords
This publication has 60 references indexed in Scilit:
- Investigation of effect of polyurea on response of steel plates to impulsive loads in direct pressure-pulse experimentsMechanics of Materials, 2010
- Micromechanisms of ductile fracturing of DH-36 steel plates under impulsive loads and influence of polyurea reinforcingInternational Journal of Fracture, 2010
- A Multifunctional Capacitive Sensor for Stretchable Electronic SkinsIEEE Sensors Journal, 2009
- Fracture and Delamination of Chromium Thin Films on Polymer SubstratesMetallurgical and Materials Transactions A, 2009
- On the interface debond at the edge of a thin film on a thick substrateActa Materialia, 2002
- Experimental and analytical necking studies of anisotropic sheet metalsJournal of Materials Processing Technology, 2001
- Effect of interfacial compliance on bifurcation of a layer bonded to a substrateInternational Journal of Solids and Structures, 1997
- Nonlocal continuum effects on bifurcation in the plane strain tension-compression testJournal of the Mechanics and Physics of Solids, 1995
- Fracture of metal-polymer line structures. I. Semiflexible polyimideJournal of Applied Physics, 1994
- Crystallographic texture, anisotropic yield surfaces and forming limits of sheet metalsMaterials Science and Engineering, 1987