Influence of stress state and strain rate on structural amorphization in boron carbide
Authors:
- 15 March 2012
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 111 (6) , 063523
Abstract
The reduced performance of B4C armor plate for impact against tungsten carbide penetrators beyond a critical velocity has been attributed in the literature to localized amorphization. However, it is unclear if this reduction in strength is a consequence of high pressure or high velocity. Despite numerous fundamental studies of B4C under indentation and impact, the roles of strain rate and pressure on amorphization have not been fully established. Toward this end, rate dependent uniaxial compressive strength and rate dependent indentation hardness, along with Raman spectroscopy, have been employed to show that high strain rate deformation alone (without concurrent high pressure) cannot trigger localized amorphization in B4C. Based on our analysis, it is also suggested that rate dependent indentation hardness can be used to reveal if a given B4C ceramic exhibits amorphization under high pressure and high strain rate loading. It is argued that when amorphization does occur in B4C, its dynamic inelastic properties degrade more severely than its static properties. Finally, it is suggested that dynamic hardness, in conjunction with static hardness, can be used as a measurable mechanical property to reveal the incidence of amorphization in B4C without the need for postmortem TEM or Raman spectroscopy analyses.Keywords
This publication has 31 references indexed in Scilit:
- Predicting variability in the dynamic failure strength of brittle materials considering pre-existing flawsJournal of the Mechanics and Physics of Solids, 2011
- The relation of failure under 1D shock to the ballistic performance of brittle materialsInternational Journal of Impact Engineering, 2008
- Dynamic Fracture of Ceramics in Armor ApplicationsJournal of the American Ceramic Society, 2007
- Sphere Impact Induced Damage in Ceramics: II. Armor-Grade B4C and WC2005
- Dynamic compressive strength of silicon carbide under uniaxial compressionMaterials Science and Engineering: A, 2001
- Densification and Mechanical Properties of B4C with Al2O3 as a Sintering AidJournal of the American Ceramic Society, 2000
- Micromechanisms of deformation in high-purity hot-pressed aluminaMaterials Science and Engineering: A, 2000
- Indentation size effects in crystalline materials: A law for strain gradient plasticityJournal of the Mechanics and Physics of Solids, 1998
- Shock-wave strength properties of boron carbide and silicon carbide.Journal de Physique IV, 1994
- Critical Appraisal of Limiting Strain Rates for Compression Testing of Ceramics in a Split Hopkinson Pressure BarJournal of the American Ceramic Society, 1994