The Wear Performance at High Temperatures of ZrO2-Reinforced Aluminum Matrix Composites Produced by Mechanochemical Reaction Method
- 15 May 2020
- journal article
- research article
- Published by ASME International in Journal of Tribology
- Vol. 142 (10) , 1-26
Abstract
In this study, high temperature wear performance of A356+Gr-ZrO2 aluminum matrix composites produced by the mechanochemical reaction method was investigated. After the aluminum composite powders were cold pressed (750MPa), the green compacts were sintered under 10−6 mbar vacuum for an hour at 550°C. Sintered AMCs have been characterized by Scanning Electron Microscopy (SEM), X-Ray Diffraction (XRD), hardness and density measurements. Wear tests were conducted in 2 different loads (10N and 30N), 5 different temperatures and 3 different sliding distances in the standard pin-on-disc type wear tester. Result showed that ZrO2 added to the matrix tends to cluster in grain boundaries. AMCs hardness and densities increased with increasing amount of reinforcement, and the highest hardness and density value was obtained with 12% ZrO2 added AMCs. Weight loss increased with increasing load and temperature and decreased with increasing amount of reinforcement in the matrix at all loads and temperatures.Keywords
This publication has 45 references indexed in Scilit:
- An investigation into the wear behaviour of TiB 2 particle reinforced aluminium composites produced by mechanical alloyingScience and Engineering of Composite Materials, 2011
- Mechanochemical synthesis of Al2O3–TiB2 nanocomposite powder from Al–TiO2–H3BO3 mixtureInternational Journal of Refractory Metals and Hard Materials, 2011
- Production of Hypo-eutectic Αl-Si Alloy Based Metal Matrix Composite with Thixomoulding ProcessingHigh Temperature Materials and Processes, 2010
- Effect of addition of graphite particulates on the wear behaviour in aluminium–silicon carbide–graphite compositesMaterials & Design (1980-2015), 2010
- Sliding wear behaviour of Al 6063/TiB2 in situ composites at elevated temperaturesMaterials & Design (1980-2015), 2009
- Evaluation and optimization of metal matrix composite strip produced by single roll continuous strip casting methodMaterials Science and Engineering: A, 2007
- Synthesis and characterization of high volume fraction Al–Al2O3 nanocomposite powders by high-energy millingMaterials Science and Engineering: A, 2006
- Abrasive wear of 2124Al–SiC composites in the temperature range 20–200 °CJournal of Materials Processing Technology, 2006
- The role of graphite particles in the high-temperature wear of copper hybrid composites against steelMaterials & Design (1980-2015), 2006
- Effect of mechanical alloying on the morphology, microstructure and properties of aluminium matrix composite powdersMaterials Science and Engineering: A, 2003