Cone-Beam Computed Tomography Study of Incisive Canal and Maxillary Central Incisors in Dravidian Population
Open Access
- 2 July 2024
- journal article
- research article
- Published by Springer Nature in Cureus
- Vol. 16 (7) , e63707
Abstract
Introduction: En-masse maxillary anterior retraction is necessary to attain an esthetic profile in Angle's class I bimaxillary dentoalveolar protrusion and Angle's class II division 1 malocclusion. The objective of this study was to evaluate configurational relationships between maxillary incisors and incisive canal in Angle's class I bialveolar protrusion and Angle's class II division 1 malocclusion by cone-beam computed tomography (CBCT). Methods: A total of 108 adult CBCT scans of 54-skeletal class I bialveolar protrusion and 54-skeletal class II division 1 malocclusions were retrospectively analyzed. Angles between palatal plane and axis of maxillary alveolar border (θ1), incisive canal (θ2), and maxillary right central incisor (θ3) were measured in relation to the midsagittal plane. Linear measurements such as incisive canal width (IC-IC), medial inter-root distance (Rm-Rm), posterior inter-root distance (Rp-Rp), anteroposterior distance from Rm to tangent of right central incisor (11 Rm-Cat), and left central incisor (21 Rm-Cat) corresponding to three vertical levels (L1, L2, and L3) were assessed in axial cross-sectional plane. Association among angular measurements was examined by Spearman correlation coefficient analysis. Mann-Whitney U test compared variables of linear measurements at three vertical levels. Results: Estimated distance from incisor root to incisive canal was 5-6 mm in both groups slightly influenced by skeletal class and vertical levels but not gender. Mann-Whitney test demonstrated significant differences between groups at three vertical levels (p<0.05). Only θ2 revealed a significant difference (p<0.05) between malocclusions compared to θ1 and θ3. The angular measurements for both malocclusions were positively correlated (p<0.05). Conclusion: Sagittal root-canal cortical plate distance varied significantly in both malocclusions (5-6 mm). Inter-root distance (Rp-Rp) was greater than incisive canal width (IC-IC) at all three vertical levels indicating a reduced possibility of canal invasion after maximum retraction at posterior levels.Keywords
This publication has 28 references indexed in Scilit:
- The diagnostic accuracy of cone-beam computed tomography and two-dimensional imaging methods in the 3D localization and assessment of maxillary impacted canines compared to the gold standard in-vivo readings: A cross-sectional studyInternational Orthodontics, 2023
- Cone‐beam computed tomography use in postgraduate orthodontic programs in North America and EuropeJournal of Dental Education, 2023
- Evaluation of the diagnostic accuracy of CBCT-based interpretations of maxillary impacted canines compared to those of conventional radiography: An in vitro studyInternational Orthodontics, 2022
- Comparison of distance of upper central incisor root and incisive canal in different sagittal and vertical skeletal patterns and sex: A retrospective CBCT studyInternational Orthodontics, 2021
- Correlation between collum angle and lower lip position in different Class II malocclusions - A retrospective cephalometric studyOrthodontic Waves, 2021
- Oxidative Stress and Oral Diseases2020
- Short-term cone-beam computed tomography evaluation of maxillary third molar changes after total arch distalization in adolescentsAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2019
- Approximation and contact of the maxillary central incisor roots with the incisive canal after maximum retraction with temporary anchorage devices: Report of 2 patientsAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2015
- Anterior alveolar dimensions among different classifications of sagittal jaw relationship in Saudi subjectsThe Saudi Dental Journal, 2010
- Cephalometrics for you and meAmerican Journal of Orthodontics, 1953